(1) The characteristics of the cam divider are 1, and the structure is simple: it is mainly composed of a three-dimensional cam and a divider. 2, accurate action: both in the segmentation area and static area, there is accurate positioning. No other locking elements are needed at all. Arbitrarily determined dynamic-static ratio and division number can be realized. 3. Smooth transmission: the three-dimensional cam curve has good motion characteristics, smooth and continuous transmission, small vibration and low noise. 4. High output segmentation accuracy: the output accuracy of the frequency divider is generally ≤ 50 ″. Up to ≤ 30 ". 5. Good high-speed performance: there is no gap between the three-dimensional cam of the divider and the divider wheel, and the impact vibration is small, which can realize high speed, up to 900 rpm. 6. Long service life: The standard service life of the divider is 12000 hours. (2) Installation of cam distributor:1; Machine body installation: (1); The divider is a high-precision dividing mechanism after precise machining and correct assembly and adjustment. Before use, users are not allowed to adjust, disassemble and assemble without authorization. (2) Confirm whether the installation surface of the partition is damaged. If it is damaged, repair it with oilstone. (3) Align the positions of the input shaft and the output shaft, fill the locating pins and tighten the screws evenly. (4) The separator bears the action of pulsating load torque, and the installation must be very firm. Due to the high verticality or parallelism of the installation surface of the divider relative to the input and output shaft, the installation base surface of the equipment must ensure that the input and output shaft direction of the divider is coaxial with the input and output direction required by the equipment. Not skewed or eccentric. Otherwise, it will not only affect the output accuracy, but also seriously damage the frequency divider. Because at this time, the divider is in an abnormal stress state. 2. Installation of input and output shafts: The connection between the input and output shafts of the divider should be rigid in the rotation direction, free from reverse impact and stable in rotation. Pay attention to the installation of rotary table, sprocket, pulley, gear, flange and other connections on the input and output shaft of the grain separator.
For more information about project/service/procurement bidding, and to improve the winning rate, please click on the bottom of official website Customer Service for free consultation:/#/? source=bdzd