Introduction of gas producer (patented product)
1, microcomputer controlled automatic ignition and automatic temperature control.
2, there is no need for a tall chimney, and the fuel gasification process completely realizes completely smokeless combustion.
3. The operating cost is 50% lower than other common coal stoves.
4. The combustible time of a fuel exceeds 65438 0 hours.
Product characteristics of environmental protection and coal-saving boiler
1. The coal-fired gasifier produced by our company is made of high-quality steel plate, which is fully welded and formed, with high strength, corrosion resistance and elegant appearance. The water jacket of the furnace is connected with the water jacket of the upper heat exchanger, with staggered internal pipes, large heating area, strong secondary heat absorption and high thermal efficiency.
2. Multi-row direct-fired furnaces with coal inlet and ash outlet.
3. High thermal efficiency, fast heating speed, novel and unique structure, small volume, long service life, low operating cost, simple operation, energy saving and environmental protection. Known as a "fool, lazy" boiler.
Main uses of environmental protection and coal-saving boilers
Institutions, enterprises, hospitals, schools, hotels, hot water for heating, bathing, catering and aquaculture, especially in communities without central heating, are the best choice products.
The product has a closed coal inlet, a closed slag outlet and a closed ash outlet. Between the generator and the heat exchanger, there is a handle for gas distribution and rotation, and it is equipped with an automatic electronic igniter, an electronic control box and a boiler scale preventer.
Installation of environmental protection and coal-saving boiler products
1. In order to achieve good heating and bathing effect, please install the stove in a well-ventilated and bright room. During installation, valves should be strictly installed at the water inlet and outlet between the radiator or bath water storage tank and the furnace to ensure that there is enough water in the furnace water jacket.
2. Articulations must be installed at the joint between water supply and return pipe to facilitate maintenance.
3. A drain valve should be installed at the lowest point of the system, and an exhaust pipe should be installed at the highest point of the system. The highest point of the exhaust pipe should be higher than the top of the supply water tank or bath water storage tank.
4. The hot water circulating pump must be installed in the heating and water supply system.
Instructions for use of environmental protection and coal-saving boiler products
1, carefully check whether all parts of the circulation system meet the requirements of safe heating or bathing before use.
2. When water is injected, it is supplemented by the supply water tank, and the radiator is tightened to run off, so as to eliminate gas accumulation until the system is filled with water.
3. After the furnace is lit with wood, put in coal in time, fill the furnace with coal, then close all oven doors, turn on the fan to supply air to the furnace, and turn the gas distribution handle, and the igniter will automatically ignite the gas when the gas concentration reaches; When adding coal for the second time, open the ash chute first, then open the charging door, close all oven doors after adding the material, and automatically ignite after opening the fan.
4. When heating, turn off the water supply pump switch, turn on the heating valve and turn on the hot water pump switch for heating. When taking a bath, turn on the switch of the cold water pump, supply water to the reservoir, and turn off the heating valve to take a bath.
5, ash room must avoid too much dust, so as not to burn out the grate.
6. Pay regular attention to the water level of the water tank and bath water storage tank during use, and keep enough water in the water tank.
7. The use of multi-row direct-fired stoves is the same as that of traditional stoves.
Matters needing attention of environmental protection and coal-saving boiler
1. Don't install the domestic stove in the bedroom or the room communicating with it to prevent gas poisoning.
2. Before using the stove, the exhaust and decompression system must be directly installed outdoors. It is forbidden to install valves on the inlet pipe and outlet pipe to prevent the water jacket from being compressed.
3. It is forbidden to use without water.
4. When the water is stopped in winter, the water in the system must be discharged to avoid freezing and cracking the stoves and pipes, otherwise the adverse consequences will be at your own risk.
Maintenance and maintenance of environmental protection and coal-saving boiler
1. When the furnace is shut down in summer, don't let off the water in the system to prevent the system and the furnace from being corroded. Keep the stove dry and ventilated. It is forbidden to wrap the stove with plastic sheets.
2. There should be a rain cap above the chimney of the stove to prevent rainwater from entering the stove and reduce the service life of the stove.
3. Observe and check regularly during use, and remove the scale in the water jacket in time.
4. Non-factory workers are not allowed to disassemble or refit. If you have any questions, please contact the factory in time.
Please read the instruction manual of the product carefully before use, and the user shall be responsible for all accidents caused by improper use.