2. Look at this seal. Real certificate seals are generally printed with red fluorescent anti-counterfeiting ink, and some are stamped by hand. During inspection, one should pay attention to whether the color of the seal is correct, and the other is whether it is clear from various angles.
Third, it depends on whether the contents of the seal and the date of issue are clear. The contents of seals are different in different periods, and * * * is divided into three stages.
The first stage is before June, 2006 54 38+ 10, and before June, 65438+ 10, with the seal of the Vehicle Administration Office of the Public Security Bureau of XX Province.
The second stage should be "implementation"
In the third stage, according to the requirements of the Notice on Changing the Seal Name of Motor Vehicle Driving License, Driving License and Registration Certificate, the seal was changed to "Traffic Police of Public Security Bureau of XX Province (autonomous region, municipality directly under the Central Government) (prefecture, league) after July 13.
3. Look at the font. Except for printing fonts, all fonts in the certificate are printed by a pin printer, and the fonts have obvious pinholes.
The seal on the driving license is the dmv of XX traffic police detachment or XX traffic police detachment, and the fonts used are all patented anti-counterfeiting fonts. This font can only be typed by combining the printer customized by the Ministry of Public Security with the font library in the vehicle management office software. Both laser printers and inkjet printers print false certificates. The most obvious features of this font are the numbers 5 and 0,2001and 10, which were adopted all over the country.
Let's start with the * * on the "5", which consists of two parts. The first part is horizontal, then it bends down, and then it goes up. The degree of upward is basically the same as that of horizontal. One kind of false certificate is that it bends directly downward without a cross, and then bends directly upward, and the upward part exceeds the cross. So, let's talk about "0" and "0"
4. Look at the model of the vehicle. As mentioned above, the second and third place in the brand model of driving license is the total mass of the vehicle, and three places can be used if it exceeds 100 tons. These two figures can be compared with the total quality of the driving license endorsement to see if they are consistent. The third place in the total quality column is generally rounded, but some third places are "5" instead of ".
5. Look at the secondary license. The second deck is also an integral part of the driving license. First of all, it depends on whether the second-level license and the first-level license are consistent, mainly depending on whether the workmanship of the certificate and the font endorsed on the certificate are the same. When the fonts of the main and secondary cards are different, the parties will cheat the traffic police on the grounds that the secondary card of the driving license is lost. However, according to Article 30 of the Regulations on Motor Vehicle Registration, the driving license will not be taken back after it is reissued or renewed.
6. Look at the photos of these vehicles. Because the overload of the country is calculated by axle load now, some car owners add axles privately in order to pull more goods and not pay more road maintenance fees. Therefore, only after adding the axle, the original photos in the vehicle driving license will be replaced. The identification of this fake driving license mainly depends on whether the approved quality of the vehicle is consistent with the photo. For example, the driving license of 10 ton is the rear three-axle car. In this case, it is necessary to pass the public security traffic information.