The structure of the concrete cutting machine is very important. Only the cooperation of every detail can achieve the final effect. Understanding it clearly can lead to better use. Zhongda Consulting will give you a detailed introduction to the structure of the concrete cutting machine.
At present, the concrete cutting machines on the market vary from good to bad, and some are far from being able to adapt to and meet the needs of users.
New concrete cutting machine.
The concrete cutting machine is composed of six parts: a frame, a turning table, a cross-cutting mechanism, a horizontal cutting vehicle, a hydraulic system and an electronic control system.
1. The frame
is composed of left and right longitudinal beams, cross beams, columns, racks, pointed rails, etc. Its main function is to make the horizontal cutting vehicle move horizontally on the rails and The cross-cutting mechanism performs vertical lifting movement on its track.
2. Cross-cutting mechanism
It consists of cross-cutting frame, transmission and spanning device, guide wheel, swing device, cutting wire, etc. The transmission and spanning devices drive the cross-cutting frame to cut the blank vertically, and the cutting wire swings in both directions at the same time.
3. Horizontal cutting car
It consists of a frame, a scraper device, an edge trimming device, a transmission device, a thread hanging column, a sheave group, a flat wheel group, etc. There are two sets of groove wheels and two sets of flat wheels on both sides of the horizontal cutting car. The transmission device drives the horizontal cutting car to walk back and forth on the pointed rail and flat rail to achieve horizontal cutting and "bread head" cutting.
4. The turning table
It consists of a turning frame, a cart, a trolley, a turning main oil cylinder and a traveling oil cylinder. Its function is to use the blanks placed horizontally on the turning table cart. The body flips forward 90° and moves to the cutting position to perform horizontal, vertical and six-sided cutting. After completing the cutting, it flips back to the starting position.
5. Hydraulic system
It consists of oil station, motor, oil pump, various valves, pipe joints, etc. The main function is to make the turning table flip 90° smoothly and accurately, and the cart and trolley move to the corresponding position synchronously.
6. Electrical control system
Achieve manual and automatic control of all actions as required.
For more information about engineering/service/purchasing tender document writing and production to improve the bid winning rate, you can click on the official website customer service at the bottom for free consultation: /#/?source=bdzd