What are the precautions for driving test in different places?

First, five things to get on the bus 1. If there is no limit on the starting time after getting on the bus, close the door first and pay attention to whether the door light is turned off. This is the key. 2. Step on the clutch with your left foot, hold the steering wheel with your right hand, adjust the seat with your left hand, and adjust your left foot to make it slightly bent. You should also pay attention to moving back and forth to stabilize your seat. Adjust the backrest to 90 degrees, and pay attention to whether it is stable before and after. Then put your hand on your head and measure whether the height is the same as usual. If it is too low, be sure to put the seat cushion and adjust it. 4. Adjust the left and right rearview mirrors to a proper position. Key points for adjusting the left rearview mirror: put the horizontal line on the center line of the rearview mirror, and then adjust the edge of the car body to mirror1/4; Key points of adjusting the right rearview mirror: place the horizontal line at the 2/3 position of the rearview mirror, and then adjust the body edge to mirror 1/4. There is still a chance to debug before reversing into the warehouse. At this time, adjust the rearview mirror angle downward until you see the fender above the front and rear wheels. Try the clutch again after fastening the seat belt. Step on the clutch with your left foot. As long as your left foot can bend a little, or you can readjust it. Try to put on the brakes again, try to fill the gas door, and make sure there is no problem before starting the exam. Second, the clutch control body should be stable, slow and even. The clutch must be well controlled. If there are signs of stopping when the direction hits one and a half laps, you should immediately release the clutch, otherwise you will be given a "stop halfway" within 3 seconds. On the contrary, press the clutch slightly when the direction turns back, otherwise the test car will rush up like a horse, especially pull over. This is a technical job, so be bold and cautious. Third, stop in the middle 1, the new test regulations are not normal. If the speed suddenly slows down from fast, it is considered to stop in the middle, no matter whether your car stops or not, so it is best to control the speed. It doesn't matter if you slow down, the key is uniform speed! There is a sensor in the car. Some places are installed on the clutch, and some places are installed on the brake pedal. Don't loosen the clutch greatly after starting, or you will stop halfway. Try to find a suitable reverse gear immediately after starting, and don't move the clutch. It is easy to stop halfway without stepping on the foot brake. When stopping, the foot brake must stop. Fourth, the anti-rolling examination room with brakes is uneven and easy to slide back when starting. Pay attention to the brake when the clutch with brake is loose to the critical point, and then release the brake. Starting with the brakes can avoid tumbling. Slowly lift the clutch until the body shakes slightly, and then release the brake. This is the same as starting on a slope, which can prevent slipping. Practice step by step, the exam without steps can't stand the test, because you are not familiar with the examination room and the car, and you can only pass the exam if you make the familiar steps. Why do some students usually practice well? They always say that when exams are tense, their minds will go blank. Because their usual practice has no steps. V. Other notes 1, confirm your own test channel, and in case of mistakes on the spot, be sure to return to the original channel for testing. Last time, one of my classmates took the third pass, and when he backed into the warehouse, he died. The driver came and drove back, parked the car at the starting point of the fourth passage, and the classmates got on the bus in a daze. Unexpectedly, at the end of the test, the computer prompts that "I feel uneasy and fail to follow the prescribed route". This classmate 2. Because subject 2 is different from subject 3, you can scan the gear with your eyes when you hang it. Don't go into third gear in first gear and fourth gear in reverse gear, and you will be judged unqualified as soon as you start. 3. Practice your direction when you are practicing, and don't look at the steering wheel, or you will miss the train if you park sideways.