1. Open the rear cover and take off the belt. Taking off the belt is very simple. Lever out the belt with a screwdriver and turn the belt plate gently by hand, and the belt will automatically fall off!
2. Remove the upper cover plate, one screw on the left and one screw on the back, and then push the whole plate from front to back.
3. Remove cement blocks, control panels, boxes containing washing powder, and remove threads and all visible parts.
4. Remove the four screws on the base, which are the screws under the fixed roller, so that it is convenient to take out the roller.
5. Remove the plastic ring clamp of the front roller, remove the screw and pull out a thread to finish the work!
6. Take out the drum. There are no screws on the left and right spring hooks. After removing the cement block above, take out the hook and lift the drum out.
7. Remove the front cover of the drum and do not move other parts!
8. Take out the inner cylinder and install the washing machine bearing on the outer cylinder. There are three fittings, a sealing ring inside and a bearing outside!
9. Next, you can replace the bearing. Pay special attention not to knock into the bearing with a hammer when installing!