What is the function and principle of the baler?

First, the working principle of the packaged object is basically in the middle of the baler. First, the upper right body rises and presses the front end of the belt, tightening the belt and tying it to the object. Then the upper left body rises and presses the lower belt at a proper position, and the heating plate extends between the two belts. The middle jacking knife rises to cut the belt. Finally, the next tape is sent to the correct position to complete a working cycle. 2. workflow: the belt is delivered to the correct position → the binding signal is received → the brake is released, and the main motor is started (1)→ the right top knife is lifted and pressed on the slide plate (2) → the T-shaped guide plate retreats (3)→ the belt withdrawal probe (4) is approached by the switch → the main motor stops rotating, and the brake is attracted (5)→ the belt withdrawal motor of the baler rotates. Pull out the belt for 0.35 seconds (6)→ Tighten the belt and tie it to the object (7)→ Start the main motor for the second time. Pull the belt (8) with the brake → Tighten the belt (9)→ Lift the upper left body and press the lower belt (10)→ Insert a heating plate (165438+) between the two belts to cut the belt (12)→ Lower the center jack (13) or so. → Slide back (17)→T-shaped guide reset (18)→ Proximity switch induction feed probe (19)→ Feed motor starts to drive the adhesive tape. Bring the top of the belt to the T-shaped guide plate (22)→ the proximity switch senses the double probe (23)→ the main motor stops running, and the brake is engaged (24)→ the baler completes a working cycle. For more details, please refer to/