The advantages are:
1. Careful selection of raw materials
The wood of Anxin Flooring is carefully selected, and these wood are from Russia, Brazil, Africa, South America, and North America, because these woods grow slowly, which is related to climate and temperature. The wood is tight and the stability is particularly good. After the wood was transported back, a vertical section was used to take the center material of the tree as the floor. Remove the scraps, and the remaining scraps are not stable; small manufacturers often purchase them at low prices.
2. Select boards for processing and health care
Pick out the floors with defects in appearance and eliminate them. Qualified products enter the drying room for health care. After a period of time, the surface layer is polished to ensure the smoothness of the surface layer. The short side incision is made first, and then the two sides are incised. Because the imported machine is used, the incisions are consistent and there are no big or small ends, so there will be very little paving loss in the future.
3. Tenfer paint, a world-recognized environmentally friendly paint
Anxin flooring uses German Tenfer paint, which is recognized as the most environmentally friendly paint in the world. It has the characteristics of super wear resistance, environmental protection, good gloss and feel, etc. It can be brushed with steel wire brush or steel ball. Anxin uses dust-free spray paint, and the total length of the machine is 128 meters. Currently, only Nature and Anxin use this kind of machine. Inspect again and pick out the floors with defects and color differences. This is a process that is invisible to everyone. This is where the price difference lies. If there is one less process, the cost will be lower.
Finnish Taier glue is higher than the European E0 environmental protection standard
Using Finland Taier glue, the world's largest adhesive manufacturer, focusing on environmental protection. The amount of formaldehyde released is less than 0.1ppm, which is definitely higher than the European E0 environmental protection standard. In the middle is the high-quality base material produced by Daya. The density of the base material and the strength of the board body are all better than the national standards. It is not easy to deform. The unique and efficient locks last long and there are no seams.