What are the construction steps of fringed wall film? Foshan Qing da run Cai

Taishir texture wall film is a patented technology exclusively developed by Shunde Qingda Runcai Coatings Co., Ltd. in Shunde, the hometown of coatings in China. The decorative effect of textured wall film made of wall film paste and technology is similar to that of wallpaper, but it is more environmentally friendly, more energy-saving, more durable and more cost-effective, which can overcome the common shortcomings of ordinary paint and wallpaper. It has the characteristics of environmental protection, waterproof, mildew-proof, good adhesion, wear resistance, strong decoration and simple construction. It is a new type of wall decoration product integrating high technology and elegant art. The main raw materials of textured wall mask paste are composed of water-based polymer resin, pigments, fillers and additives. No harmful components are released, which is green and environmentally friendly. Construction steps of textured wall membrane 1. At the grass-roots level, the water seepage and leakage of the wall should be handled first, and the wall pit should be filled with water-resistant putty with good adhesion. The larger wall pit can be filled directly with cement mortar, and then leveled with putty as a whole. Note: Setting the angle of yin and yang of the wall to be vertical will greatly improve the overall process quality. It is also suggested that appropriate white cement or gypsum powder should be added to the putty at the external corner to increase its strength and avoid damaging the corner. Second, after the putty at the base of the back cover is dry, use 180# water sandpaper to smooth the scratches on the wall, and then roll or brush the sealing primer. If the construction site has poor ventilation, poor lighting, high humidity and high alkalinity of the wall, it is necessary to choose corresponding sealing primer, such as alkali-resistant, moisture-proof, mildew-proof, sterilization and enhanced adhesion. Third, after the primer is sealed, roll a layer of background color evenly with the wall film slurry with adjusted color. 4. After the texture background color is dry, use a sponge feeding roller with a thickness of about 0.6-0.8MM to coat the wall film slurry, and then use a texture roller to roll out the required texture. Fiber texture: fiber texture is generated by random rolling on the wall with a fiber texture roller, and the number of rolling determines the density of fiber texture. Dermatoglyphics: After coating the first layer of wall film slurry, roll the fiber texture horizontally with a fiber texture roller; after the surface is dried, coat the second layer of wall film slurry; roll the fiber texture longitudinally with a fiber texture roller; and polish after the surface is dried. Bouquet texture: firstly, the horizontal stripe texture is vertically rolled on the wall with a horizontal stripe texture roller, and then the horizontal stripe texture is vertically rolled on the wall with a vertical stripe texture roller. The number of rolling determines the density of bouguer texture. Stripe texture: vertical rolling on the wall with vertical texture roller will produce stripe texture, and the number of rolling determines the density of stripe texture. Combination mode; Combined texture is produced by vertical rolling on the wall with a combined texture roller. Concave-convex texture: rolling with rubber embossing roller will produce concave-convex texture, so pay attention to the pattern when rolling. 5. After the surface textured film is dried, smooth the textured surface with 180# water sandpaper, and touch it with your hands, and it feels soft. Top coat: brush evenly with a fine brush or spray with a spray gun. Screen printing: the concentration of paint should not be too low, otherwise the fluidity of paint will affect scraping. Self-made scraper, a 3-4m2 thick rubber skin is sandwiched between two splints,