First, how to install the magnetic stripe screen window
1. Material preparation: prepare four triangles for fixing the outer frame and pvc link; 2 clips for fixing the screen window; Polyester polyester gauze; The four strips correspond to the four corners of the window.
2. Measuring and framing: When installing the magnetic screen window, you should first measure your own window frame size. When you know the size, insert the pvc strip into the triangle to make a frame.
3. Yarn pressing: spread the prepared gauze on the finished frame, and remember to lay it flat to avoid affecting the beauty of the window. Pawnshops can use slotted magnetic stripe screens to press gauze into pvc strips. What needs to be reminded here is to remember to push the gauze into the pvc strip and finally press it outside.
4. Cut off excess gauze: After installation, cut off excess gauze with scissors.
5. Sticking the adhesive tape: suck the adhesive tape on the magnetic tape in the slot, install the second clip at a position about 30% away from the top of the frame, pull the protective film of the adhesive tape away at the clip installation position, and install the clip.
6. Screen installation: After all the steps are completed, clean the window frame and keep it dry, then tear off the protective film attached with the magnet. After fixing the position, press the magnetic tape hard to install the screen.
7. Rope installation: After the magnetic stripe screen window is installed, the last step is to install the rope. The main purpose of stringing is to facilitate the opening and closing of the screen window, so strings are installed on the two triangles below.
Second, matters needing attention in installing magnetic stripe screen window
1. First, measure the size of the required installation position of the window, put two large aluminum spaces facing the small space, and cut off the aluminum and the cover plate according to the measured size. According to the installation position, drill an 8- 10 mm hole in aluminum (the size of the hole is the diameter of the selected expansion bolt). Determine the installation position of the alarm or transmitter, drill a 6mm hole in the upper corner of the first window frame, and introduce one end of the wire rope into the room with sufficient length. Place the aluminum material in the required installation position of the wall, drill 8- 10 mm holes on the wall in turn with an electric hammer, and fix them on the wall with expansion bolts; Tighten the wire rope in turn, being careful not to use too much force, and tighten it continuously for 3-4 times until the wire rope reaches the required tightness.
2. Clamp the wire rope between the fastening washers and lock it. Wire ropes are always woven up and down around a set of closely spaced fastening screws. Sealing the cover plate: fasten the cover plate and rivet it tightly with rivets (note: don't use too much force when riveting the rivets to prevent the cover plate from deforming), and cut the rivet core with diagonal pliers. According to the height of the window, determine the number of transverse steel wires (generally pull a transverse steel wire at 150cm), determine the position of transverse steel wire rope, pull a standard wire to ensure that the cross buckle is on a horizontal straight line, and pull the steel wire rope to the clamping position and lock it with the cross buckle. Then, the wire rope is introduced into the room, and the two ends of the exposed inner core are connected to the two wires of the alarm or transmitter respectively and fixed on the wall.
3. Clean the screen once a month: wipe the screen directly with a wet towel. When maintaining the invisible screen window, try not to let water enter the slideway below the screen window. If there is dust on the slide below, clean it with a vacuum cleaner or a hair dryer.
In the above article, I told you the installation method of magnetic stripe screen window and the matters needing attention in installing screen window. I believe that everyone must know something, and these related contents must be made clear before installation. I hope this can help everyone.