First of all, remove the logo, install the wheel on the dynamic balance instrument, and select the fixer suitable for the size. First pull out the scale on the dynamic balance instrument, measure it, and then input it into the first controller (for example, 7.2).
"Enter the measured value"
Step 2, take out the bending ruler to measure the rim width and input it to the second controller (for example, 7.5).
"Measure the width of the wheel hub"
"Enter a value"
Step 3, enter the rim diameter in the controller, and press STRAR to start.
"Check wheel hub dimensions"
"Enter a value"
After the inspection stops, the computer will measure the weight of the counterweight that needs to be increased inside and outside the rim. First, install the outside, rotate the tire and knock on the counterweight according to the prompt.
"Test results displayed"
Dynamic balance is only for a single tire, the purpose of which is to make the tire itself not shift its center of gravity when it rotates. For dynamic balance, just remove the tire, start the balancing machine, turn it around and see the value displayed by the machine.
"Carry out dynamic balance detection"
At the same time, tap the balance weights corresponding to the values on both sides of the wheel hub (a small tin block with buckle, marked with weight), but it should be noted that, for example, if 10 and 15 are displayed on the left and right respectively, you should tap two balance weights weighing 10 and 15 on the left and right respectively at the same time, instead of just tapping one on the right 5.