What type of cutter head is used for slotting and bending aluminum-plastic plate with edge trimmer?

Use a 6 mm, 90-degree V-knife to cut aluminum just enough to see it, and then bend it. Grooving knife: Using the motor-driven grooving knife, one or more grooves can be easily opened on the inner wall of the pipe. Thereby further enhance that strength of tube expansion. We can also produce special grooving knives according to the requirements of users to meet the different requirements of different users.

Extended data:

1) slotting machine has two functions, and single diamond cutting wheel is used for cutting; The use of double diamond cutting wheels can be used as grooving.

2) The groove width can be adjusted by the distance circle between two diamond cutting wheels.

3) The grooving machine must choose high-quality diamond cutting wheels, and replace two diamond cutting wheels at the same time. It is best not to mix the old and the new.

4) Before using the grooving machine, be sure to check the dynamic balance of the two diamond cutting wheels.

1. Before starting the machine tool, you must carefully check whether the tools, nuts and screws of all parts are firm, and tighten them in time if they are loose;

2. Pay attention to the cutting direction when installing the tool, and don't reverse it;

3. The main knife rotates clockwise;

4. Before grooving, confirm whether the pneumatic device is turned on, whether the workpiece is pressed on the movable push table and pressed against the positioning plate, and keep your hands away from the knife edge;

5. When the machine fails, immediately cut off the power supply, stop running, and assign personnel to maintain and adjust. Machine tools are not allowed to run in spite of illness;

6. Before processing materials, check whether there are nails, sand cracks, etc. On tools, prevent tool joints from flying out and hurting people;

7. When cleaning and lubricating the machine tool, and when removing the saw blade and cleaning the chips, the power supply of the machine tool must be cut off.

8. Machine tools should be operated, adjusted and maintained by designated personnel, and it is strictly forbidden for people who are not familiar with machine tools to use them;

9. Workers should wear earplugs, goggles and other labor protection articles when operating.

10. The maintenance of the machine shall be carried out in accordance with the equipment operation, maintenance and maintenance system.

Baidu encyclopedia-slotting machine