Technical parameters and characteristics of hot air circulating oven

In modern society, the hot air circulating oven has been upgraded several times to replace the traditional drying room, which greatly improves the thermal efficiency of the oven. The oven is equipped with an air distribution device, and users can adjust the blades before use, so that the temperature difference between the upper and lower parts is in a good state. At present, with the requirements of high-temperature sterilization, the air duct and the front and rear doors have also been modified accordingly. The fan of the oven was changed into an air-cooled standardized ring fan and became a high-temperature sterilization oven with opposite doors.

Let's take a look at its technical parameters:

1. Heating sources: steam, electricity, far infrared and electric steam.

2. Service temperature: steam heating: 50- 140℃, the highest 150℃. The temperature of electric heating and far infrared heating is 50-350℃.

3. Equipped with automatic control system and computer control system.

4. The common steam pressure is 0.02-0.8Mpa(0.2-8kgf/cm2).

5, equipped with electric heating, calculated according to type I, 15kw, practical 5-8kw/h.

6. Indicate special requirements when ordering.

7. If the service temperature is greater than 140℃ or less than 60℃, please indicate it when ordering.

8. Our factory dries cars, and the drying plates are uniform in size and interchangeable.

9. Drying tray size: 460×640×45

Features: 1, hot air circulates in the oven, with high thermal efficiency and energy saving.

2. Forced ventilation is adopted, and the oven is equipped with an air duct, so that the materials are dried evenly.

3. The oven runs smoothly. Automatic temperature control, convenient installation and maintenance.

4. It has a wide application range, can dry various materials, and is an ideal general drying equipment.

The above is the article I brought to you, hoping to let you know something about the hot air circulation oven. Hot air circulation oven products are complete in types and models, with high cost performance, safety and reliability, and lifelong maintenance.