Standard configuration of air shower room: the arc angle of the outer box is designed by our company's patent which is more suitable for the principle and requirements of clean room. Adopt fully automatic control operation, double-door electronic interlock, infrared induction automatic shower, double door lock when showering. Cold plate plastic spraying series adopts multi-layer pickling technology, which can not be treated by electrostatic spraying. All stainless steel doors, doorframes, handles, thickened floors and air nozzles are used as basic configurations. Matters needing attention in the use of Chongqing air shower room: regularly use instruments to determine the technical indicators of the equipment, and deal with those that do not meet the technical parameters in time. According to the actual use situation, the filter material in the air primary filter is disassembled and cleaned regularly. When it is found that the wind speed becomes smaller, first check whether the surface of the air primary filter is black. If it is black, it means that the front filter contains more dust and the resistance increases, so the non-woven fabric in the primary air filter should be removed for cleaning or replacement.
When the non-woven fabric is replaced or cleaned, but the wind speed cannot be increased, it means that the HEPA filter has been blocked, resulting in increased resistance, and the HEPA filter should be replaced. When replacing the HEPA filter, it is necessary to remove the ball spraying plate, take out the HEPA filter, and replace it with a new HEPA filter according to the specifications and models of the original HEPA filter. When installing, confirm the arrow mark on HEPA filter, and the arrow should point to the air flow direction. And ensure a good seal to prevent leakage. After the high efficiency filter is replaced, it is necessary to confirm that there is no leakage in the frame, and use the dust particle counter to detect it, and it can only work normally after reaching the technical index. Repair the circuit regularly. If there is any fault, please refer to the electrical schematic diagram for maintenance. Close the door regularly to align the electronic lock with its lock hole, so as to prevent the lock pin from getting stuck.