The synchronous pulley and the belt type only need to match the tooth type, that is, an , other number of teeth can be customized.
The calibration of the synchronous belt is mainly a power calibration, that is, when considering load acceleration and deceleration, the load power of the synchronous belt during smooth operation cannot exceed the allowable power, and there is a minimum number of teeth of the synchronous pulley. According to the manual, too few teeth will cause excessive deflection of the synchronous belt and shorten its life. Therefore, a large synchronous wheel should be used within the positioning accuracy requirements.
I don’t know your accuracy requirements and positioning control method. If it is open-loop control, it is recommended to use synchronous belts such as t5, t3, 5m, 3m, etc., which can round off the pulse amount. If it is closed-loop, then It will be all right.