How to fill in the application form for Shenzhen utility model patent? Introduction of patent application

If you applied for a practical patent in Shenzhen, are you still worried about how to fill out the application for a practical patent in Shenzhen? Of course, we understand your sadness. After all, there are many contents in the application, and there are many points to pay attention to. This paper has compiled some relevant documents to fill in, hoping to help your application. Fill in the series documents of utility model patent application 1. Let's talk about the actual operation steps first: first look at the example of writing a utility model application (specification), and then write the corresponding parts of your patent according to the gourd painting gourd ladle. After that, check, check and recheck, and copy the relevant parts into the above-mentioned documents (claims, specifications, drawings, summaries of specifications and illustrations). Finally, fill in the actual request for the new patent, the list of documents submitted after the application and the request for reducing the cost. All that's left is to print a copy of all the documents except the sample documents, and then make another copy. If there is no copier, you can print two copies; ; This is not recommended. In fact, the patent office also requires one copy to be printed to ensure that the two copies are highly consistent. ; So, be sure to keep two copies exactly the same! Finally, it can be handed over to the State Patent Office. 2. Specific operation (1) Read the sample document carefully. For specific operation, I suggest you open the document "Example of Writing an Application for a Utility Model (Instruction)" first, that is, this document: p0200605 10438053585660. Doc, so you might as well watch it a few times. If you still don't understand, I suggest you look at other patent formats and writing methods. The more the better, the more you see. Until it is fully understood. Don't bother, the world is most afraid of being serious. As long as you are serious, you can't learn anything and do nothing. (2) Draw a gourd ladle and fill in your contents. Pay attention to strictly follow the requirements in the sample document when filling in! This is a prerequisite for a successful application. (3) After completion, perform other steps as described in step 1 above. (4) With regard to the abstract of the instruction manual, the name of the utility model, the key points of the technical scheme and the main uses, especially the main shape and structural features (mechanical structure and/or electrical connection) of the utility model shall be clearly stated. The full text does not exceed 300 words, and commercial propaganda language is not allowed [often writing long articles, which are thousands of words at a time, please pay attention to those who digress from Wan Li! To the point, to the point], I suggest you write a paragraph in the technical field in the manual first, and then summarize it highly and put it here within 300 words. This also ensures the high consistency of the document. The drawings must be selected from the drawings in the specification. (5) About the format of the content in the document. All documents should be typed or printed as far as possible. Especially the abstract of the specification and claims. Handwriting should be neat and clear, black, in line with the requirements of plate making, and shall not be altered. The height of characters should be between 3.5 mm and 4.5 mm, and the spacing should be between 2.5 mm and 3.5 mm. If the related documents have two or more pages, there must be a page number at the bottom of each page. It is suggested to add the words "Page N/M" to the right of the header (where N is the serial number of the current page and M is the total number of pages), but the font size should be consistent with the text size of the page number in the middle position at the bottom of the page.