Check program storage device
First of all, you need to check the devices that store programs (such as hard disk, USB flash drive, etc.). ) both. If the storage device is damaged or lost, you may need to re-import the program or rewrite it.
Import program
If the program storage device is available, the program can be imported into the machine tool controller through the control panel or PC-side software on the machining center. The specific steps may be different for different machine tools and control systems, but usually involve the steps of selecting program files, specifying the starting position of the program and setting relevant parameters.
Loading equipment
After the program is imported into the controller, it needs to be loaded into the machine tool through corresponding instructions before it can run. According to the specific processing requirements and program design, some parameters may need to be set and modified to ensure that the program can run correctly and meet the processing requirements.
Carry out pretreatment
After the program is loaded, it is necessary to preprocess the program and generate the corresponding G code and motion trajectory in the controller. The preprocessing process may take some time, depending on the size and complexity of the program. After the preprocessing is completed, the program can enter the running state.
Matters needing attention
When running the program, you must operate in strict accordance with the equipment instructions and safety requirements to avoid potential safety hazards or damage to the equipment. Before operation, carefully read the operation manual and relevant safety requirements of the equipment, and consult the equipment manufacturer or experienced technicians if necessary.