Stick your head out of the window, watch the rear wheel cross the line and brake slightly. Give it a try! I really don't believe it. After you park like this, get off and see if it's standard! Hope to adopt
How to adjust the seat to see the parking spot when reversing into the warehouse?
Do not adjust the seat after the car starts. I was about to reverse the car when the front body crossed the yellow line.
1. When the lower edge of the left rearview mirror is about two fingers wide (2-3cm) from the yellow line when reversing, immediately turn the steering wheel to the right, slowly step on the clutch and slowly put it in storage;
2. Then start looking at the right rearview mirror. If the car body is at right angles to the right side of the garage or close to the sideline, turn some steering wheels to the left (see the situation for details), and then continue to enter slowly; Adjust the distance between the garage sideline and the car body according to the principle of which side is wide and which side is facing when entering;
3. When the car body is about to be parallel to the sideline, immediately turn the steering wheel back and enter slowly;
4. When the horizontal sideline on the left side of the garage immediately coincides with the sideline under the left rearview mirror, (remember not to overlap, or it will be late) stop immediately.
How to look at the parking spot when reversing into the warehouse
Examination content
1, enter library B from starting point A, and stop.
2. Continue to enter Area C and stop.
3. Back to the warehouse B from the bracket return area and stop.
4. Return to A from library B to complete the exam.
standard
1, not following the prescribed route and sequence, unqualified.
2, the body is off-line, reversing, and stopping halfway is unqualified.
3. If the reverse warehousing is not completed for more than 4 minutes, it is unqualified.
way
There are three most common ways to reverse the car. The first type is "non-"dumping, which is common in various hypermarkets. The second type is the "one-shaped" reversing storage on the roadside, which is often called side parking. The third is the less common diagonal flip warehousing. 70% of the accompanying students think it is difficult to pull over.
First, "non-font" is put into storage in reverse.
The "non-font" reversing vehicle should be in a vertical position with its own parking space, and the B-pillar of its own vehicle can basically reverse to the third parking space based on the first parking space.
This positioning method is more suitable for novice drivers. The advantage is that it is easy to carry at one time if you master it well. The disadvantage is mechanical. If there are many vehicles on both sides or the position is narrow, it needs to be adjusted many times. Most of the accompanying students responded that this kind of reversing into the library is more common and easy to learn.
Second, "straight" side parking
"Straight-line" side parking means aiming at the car body with the front car as the reference object and turning the steering wheel to the right. When the angle between the two cars is 45 degrees, turn the steering wheel back during the observation. If the estimate is appropriate, it can be carried at one time.
This way often needs to occupy the driveway, so many accompanying students operate well in the process of reversing, but the car behind them completely loses its rhythm as soon as it honks its horn, which is easy to lead to failure.
Third, stop diagonally.
These two kinds of parking generally take one or two class hours, so escort students can master them skillfully. Of course, there are also some diagonal parking or irregular parking, so I won't go into details here. In the accompanying course, accompanying students will be trained one by one.
How to look at the parking line when reversing into the warehouse? It's fine, but I can't watch parking.
That's interesting. I'm reversing. The landlord should be taking a driver's license test. Who installed the driving school for you? Look at this line in the mirror. Please ask me again if you don't understand.
What do you think of the parking spot for reversing into the warehouse?
Test content 1, enter library B from starting point A, and stop. 2. Continue to enter Area C and stop. 3. Back to the warehouse B from the bracket return area and stop. 4. Return to A from library B to complete the exam. The evaluation standard is 1, and those who do not follow the prescribed route and sequence are unqualified. 2, the body is off-line, reversing, and stopping halfway is unqualified. 3. If the reverse warehousing is not completed for more than 4 minutes, it is unqualified. Methods There are three common ways to reverse the car. The first way is to reverse the car into a "non-"shape, which is common in various supermarkets. The second type is the "one-shaped" reversing storage on the roadside, which is often called side parking. The third is the less common diagonal flip warehousing. 70% of the accompanying students think it is difficult to pull over. I. "Non-font" reversing warehousing "Non-font" reversing warehousing vehicles should be in a vertical position with the parking space to be parked. The B-pillar of your own vehicle can basically reverse to the third parking space based on the first parking space. This positioning method is more suitable for novice drivers. The advantage is that it is easy to carry at one time if you master it well. The disadvantage is mechanical. If there are many vehicles on both sides or the position is narrow, it needs to be adjusted many times. Most of the accompanying students responded that this kind of reversing into the library is more common and easy to learn. Second, the "first line" side parking "first line" side parking is to align the front car with the body and turn the steering wheel to the right. When the angle between the two cars is 45 degrees, turn the steering wheel back during the observation. If the estimate is appropriate, it can be carried at one time. This way often needs to occupy the driveway, so many accompanying students operate well in the process of reversing, but the car behind them completely loses its rhythm as soon as it honks its horn, which is easy to lead to failure. Third, diagonal parking generally takes one or two class hours before the accompanying students can master it. Of course, there are also some diagonal parking or irregular parking, so I won't go into details here. In the escort course, I will practice for the escort students one by one.
What is the reference point for parking in reverse storage?
20 13 according to the new traffic regulations, the field test in the driving test will combine the previous pile test (inverted pole) with the field test, and the number of practice items will be reduced to five. The two test items, side parking and reversing into the warehouse, replaced the cancelled unilateral bridge crossing and continuous obstacle crossing, and became the most difficult items recognized by the students.
So, where are the difficulties of side parking and reversing storage? How should students practice and take exams? The reporter visited a number of senior coaches yesterday. Let's take a look at the difficulties and customs clearance tips.
Difficulty 1: There is no reference for hanging rod, so it is impossible to reverse.
After canceling the hanging rod as a reference, the original reversing angle (aiming head) no longer works. Although there are still marks on the ground for reference, they are not as intuitive and accurate as the benchmarks erected on the ground. For this change, students generally said that it is difficult to find the aim when reversing.
"Tips" rearview mirror and door handle reference
Without the reference that everyone is used to, it is necessary to find new reference, which is what most coaches are trying and exploring at present. Hanging rods are not allowed. We can use the rearview mirror and rear bumper to compare with the door handle and marking of the vehicle to find a better reference reversing angle.
Difficulty 2: semi-clutch control vehicle, without stopping halfway.
In the previous pile test, a pickup truck with a transfer case was used as the test vehicle, and students usually can reverse without maintaining a semi-clutch state. At present, Pu Sang is uniformly used as the test vehicle in the new driving test venue. Students need to control the speed with semi-clutch, and it is forbidden to stop halfway when reversing into the warehouse and parking sideways, which undoubtedly increases the difficulty of students' hand, eye and leg coordination.
[Tips] Grasp the clutch degree of the straight curve.
The current exam requires students to master semi-clutch very skillfully. Before training specific events, students should spend a lot of time practicing semi-clutch mastery, and they can control the speed clearly and skillfully by stepping on the deep and shallow clutch points. Even through practice, I am familiar with the subtle changes of different clutch points needed to maintain the same speed in curves and straights (curves are shallow and straights are deep). After you are familiar with the semi-clutch, you can control the speed well, and then the difficulty of passing the exam will be much smaller.
rare edition
In view of the most difficult problems in the venue examination, such as reversing into the warehouse and parking sideways, coaches are exploring teaching methods, and some coaches have come up with corresponding countermeasures. However, in the interview, most coaches are secretive about their unique cheats and are unwilling to disclose them. After hard work, we learned some customs clearance skills of coaches. Let's take a look at the mystery.
(This part of the cheats is based on students' height 170cm. Different heights and weights will affect the visual position of the reference object. Please make corresponding adjustments according to your actual situation. )
Side parking diagram
Parking by the side is easier than reversing into the warehouse, and the way of reversing is relatively unified at present.
Other methods
Tang of another driving school made a small improvement on coach Chen's method. He believes that the second step is to observe the right door handle through the right rearview mirror. When the angle of the door handle is aligned with the white line, it will be more accurate to return to the steering wheel.
Reverse storage schematic diagram
The method introduced to us by the senior driving school coach who teaches reversing is that we know that the method used by coaches is relatively popular at present (different coaches will change slightly), which is relatively simple and practical.
Other methods
For how to reverse the car into the warehouse, a coach summed up his own set of methods, and the steps were simpler.
Step one, look at the left rearview mirror when reversing. When the left rearview mirror blocks the white line, quickly kill the steering wheel to the right. Step 2: After seeing the left rearview mirror parallel to the white line of the warehouse, go straight to the warehouse. Step 3, stop when the visual position of the front edge of the warehouse is close to the left rearview mirror.
Hope to adopt, thank you.
Why do you say that everyone's order is different when reversing? Isn't parking the same?
This is the most difficult of all projects. The key point is to judge the inclination of the car body through the observation of the rearview mirror, and adjust the steering wheel accordingly. You must learn to look in the rearview mirror, or you can't pass the exam. It is difficult to express words, and it takes more practice to find the feeling.
Turn the library to the right.
1. Get on the bus and adjust the seat and backrest, adjust the left and right rearview mirrors, and adjust the rearview mirrors to the lowest level. It's best to see a little bit of the rear wheel. Fasten your seat belt. First drag the car to the right position, put on reverse gear, release the clutch, and slow down. From the driver's point of view. When the horizontal white dotted line on the ground crosses the lower edge of the left rearview mirror and is completely blocked by the rearview mirror, immediately kill the steering wheel quickly to the right, continue to retreat, and slowly retreat with your eyes on the right rearview mirror.
2. When the right rearview mirror appears in a corner of the garage, pay attention to the distance between the rear wheel and the corner of the garage. It is best to keep the distance between the rear wheel and the corner of the garage at 25-30 cm, which is twice the width of the yellow line. If it is less than 30 cm, it will return to the direction of half a circle. When the distance between the rear wheel and the corner of the garage and the sideline of the garage increases to 30 cm, it will kill the direction to the right. If it exceeds 30 cm, the left side of the car will be out of the warehouse, which will lead to a failure (the next time the car body is parallel to the yellow line, it will immediately return to the positive direction to dump the car.
3. Look at the left rearview mirror. When the horizontal yellow line crosses the lower edge of the left rearview mirror and is completely covered, step on the brake and the clutch.
4. Shift gears and leave the warehouse, and observe from the driver's point of view. When you see the yellow horizontal line of the front cover, immediately kill the steering wheel to the left and return to the positive direction when the front of the car is straightened. Keep walking. When you see the white dotted line on the ground passing through the lower edge of the left rearview mirror, step on the brake and clutch.
Dump the library to the left
1. Put the reverse gear on and release the clutch, and the speed will be slow. From the driver's point of view. When the horizontal white dotted line on the ground crosses the lower edge of the left rearview mirror and is completely blocked by the rearview mirror, immediately kill the steering wheel to the left, continue to retreat, and slowly retreat with your eyes on the left rearview mirror.
2. When the left rearview mirror has a garage corner, pay attention to the distance between the rear wheel and the garage corner. It is best to keep the distance between the rear wheel and the corner of the garage at 25-30cm, which is twice the width of the yellow line. If it is less than 30cm, it will return to the direction of half a circle. When the distance between the rear wheel and the corner and the sideline of the garage increases to 30cm, it will be killed to the right. If it is more than 30cm, the left side of the car body will be out of the warehouse, which will lead to failure (it will be killed earlier next time). When the car body is parallel to the yellow line, it will immediately return to the positive direction.
3. Look at the left rearview mirror. When the horizontal yellow line crosses the lower edge of the left rearview mirror and is completely covered, step on the brake and the clutch.
4. Shift gears and leave the warehouse, and observe from the driver's point of view. When you see the yellow horizontal line of the front cover, immediately kill the steering wheel to the right and return to the positive direction when the front of the car is straightened. Keep walking. When you see the white dotted line on the ground passing through the lower edge of the left rearview mirror, step on the brake and clutch.
Go back to the warehouse and stop to see which point it is.
Look at the left first, then look at the right,
Subject 2 How to adjust the parking position when reversing into the warehouse?
This is too simple. When driving forward, just keep the left edge out of the midpoint of the lower edge of the left rearview mirror (try to make the left edge point to the left of the middle and lower part of the mirror frame). How to judge whether the front of the car has passed the starting line of the exam depends on whether the left door has passed the starting line and stopped in the middle of the door, and then backed into the warehouse.
Go back to the warehouse and see where to park.
Before reversing, observe the distance between the garage door and the car, park the car in the middle of the garage door, roll down the window and stick your head out of the car, depending on the distance on your side, just park the car in the middle and watch.