Next, configure the engraving machine. First, install the driver of the engraving machine. My engraving machine is pickup 630, which is connected to the computer through USB interface. After installing the driver, check the port of the engraving machine in the device manager. My port is com3, as shown in figure 1. Then set the transmission rate of this port to 38.4K, as shown in Figure 2. Next, enter the Wen Tai interface and set the Wen Tai connection port as the port displayed in the device manager, and then set the transmission rate of this port to 38.4K in the question.
I hope my answer is helpful to you. If you have any questions, please contact me.
Extended data:
Engraving machine belongs to terminal equipment. Users can send instructions to the engraving machine through the computer, and the computer drives and controls the working mode of the engraving machine. The engraving machine mainly uses its own cutter to cut characters or patterns designed according to computer application programs, and then cuts on flexible media (such as paper, PVC film and plastic film) according to instructions.
When in use, the user first inputs the required characters through the graphics editing and processing software installed in the computer and matched with the engraving machine, and sets the required font and size, or makes the required graphics. After completing the design of the required engraving content, the user can send instructions to the engraving machine through the computer. The engraving knife controlled by computer and driven by engraving machine engraves the characters and images that have been designed on the computer on the carvings (usually post-it notes and plastic films). Engraving machines can also be used to cut paper or carve materials on thin metal paper.
References:
Baidu Encyclopedia-Engraving Machine (Introduction and Usage)