Where does Chengdu have industrial injury disability appraisal?

The work-related injury and disability appraisal department is the labor ability appraisal department. Most of the time, workers with work-related injuries apply for work-related injury and disability appraisal in the county-level labor ability appraisal department. Whether the employer or the injured employee applies for work-related injury identification, after it is confirmed that it belongs to the category of work-related injury, it is followed by the identification of work-related injury disability level. Usually, according to this appraisal result, we can determine what standards should be used to compensate employees who have been injured at work.

Legal analysis

If the flow rate is far below the minimum flow rate to ensure accuracy, there will be no output (such as vortex flowmeter) or the output signal will be cut off as a small signal (such as differential pressure flowmeter), which is unfavorable and unfair to suppliers. In order to prevent the loss of benefits, for a specific set of thermal energy metering equipment, the supply and demand sides often agree that a certain flow value is the "agreed lower limit flow" according to the flow measurement range and the achievable range, and agree that if the actual flow is less than the agreed value, it will be charged according to the lower limit flow. The metrological administrative department of the people's government at or above the county level may set up metrological verification institutions according to needs, or authorize metrological verification institutions of other units to perform compulsory verification and other verification and testing tasks. Personnel who perform the verification and testing tasks specified in the preceding paragraph must pass the examination. This function is usually realized in the flow display instrument. The metrological administrative department of the local people's government at or above the county level shall, according to the needs of the local area, establish public standard instruments of measurement, which shall be used after passing the examination presided over by the metrological administrative department of the people's government at a higher level. Enterprises and institutions may, as required, establish standards of measurement for their own use, and the highest standards of measurement shall be used after passing the examination presided over by the metrological administrative department of the relevant people's government. Metrological verification shall be carried out on site in accordance with the principle of economy and rationality. Metrological verification must be carried out in accordance with the national metrological verification system table. The national metrological verification system table shall be formulated by the metrological administrative department of the State Council.

legal ground

Article 28 of the Regulations on Work-related Injury Insurance: After 1 year, if the injured employee or his close relatives, the unit where he works or the agency thinks that the disability has changed, he may apply for re-appraisal of the work ability.