You can design a 4-piece mold with gear set or mechanical pull rod, which can make better use of mold space;
Pouring in the middle of the hot runner; Fixed die demoulding can adopt pull rod type;
The production cost of overlapping die is slightly higher, which can not only reduce the clamping force, but also improve the production efficiency. Personally, I disapprove of overlapping die design.
If I do this design:
I will choose a set of mold, that is, design two hangers of different sizes, and put a small hanger on the big hanger (which can be used to dry pants and other items), so that the production cost can be reduced without reducing the production efficiency, which is innovative;
I hope it helps you!