First, the cleaning steps of Chuchu Yuba
1. Confirm that Chuchu Yuba has been turned off and completely cooled;
2. Remove the light bulb;
3. Clean the lamp holder thoroughly with warm water and soft cloth;
4. If there are stubborn stains on the lamp holder, it can be cleaned with neutral detergent;
5. Choose a stable ladder or chair;
6. Stand on the chair and scrub the outside of Chuchu Yuba;
7. Completely remove the cleaning agent attached to the bulb and the outside of the fuselage with clear water;
8. Make sure that Chuchu Yuba has been cleaned and dried, and then reinstall the light bulb;
9. Open ChuChu Yuba, and check whether each function can run normally;
10, turn off Chuchu Yuba to ensure that the air in the bathroom is relatively dry and has certain fluidity.
Second, the encyclopedia of yuba knowledge
1, considering the bathroom space.
For a small bathroom, you can choose a yuba with good ventilation effect. If it is a new house decoration, you can choose to install a ceiling-type yuba that does not occupy space and has a beautiful appearance. If it is an old house decoration, you can choose Yuba according to whether the ceiling thickness is enough and whether the plug is enough.
2. Pay attention to the safety of Yuba.
To see the safety of Yuba, it is best to choose a Yuba dedicated to the bathroom. If the bathroom environment is humid and Yuba has heating function, then the box material must be durable.
3. Think about the power of Yuba.
You can choose the power of Yuba according to the bathroom area. Generally, the bathroom is 2.6 meters high, and the bathroom with two bulbs is suitable for the bathroom of about 4 square meters. 4 bubble bath bully is suitable for bathrooms of 6 square meters to 8 square meters.
4. Pay attention to the eye protection performance of Yuba.
Because children will stare at the Yuba when taking a bath, it is easy to cause blindness, so it is best to choose the Yuba with a frosted surface to reduce the damage of light to the eyes.
Yuba is waterproof.
To choose a yuba with good waterproof performance, not only the yuba itself should be waterproof, but also the switch should be waterproof, because it is connected to the circuit, which has potential safety hazards.
6. Yuba power wiring system should be standardized.
Because the power of Yuba is relatively large, the power cord for installing Yuba must be waterproof, and it is best to take dark wires instead of obvious wires. In particular, the installation of Yuba in the bathroom of old houses should pay more attention to standardization and safety in use.
7. Yuba should be installed in the center of the bathroom.
Yuba should be installed in the center of the bathroom or near the bathtub, which is not only safe, but also can maximize its function.
8. When using Yuba, it is forbidden to spray with water, because the temperature is too high, which will lead to short circuit and other dangers.
9. You can't switch the Yuba on and off frequently, and there can't be big vibration around it during operation, otherwise it will affect the service life of the heating bubble.
10, heating lamp and Yuba cannot be used at the same time.
Today, about the cleaning steps of Chuchu Yuba, the content of Chuchu Yuba Knowledge Encyclopedia is introduced here for everyone. I hope that after reading today's article, you can learn the cleaning methods of Yuba, take care of your own Yuba, and make your own Yuba have a longer service life.