1, mud solidifies quickly after combination, so it is not advisable to combine too much at one time. If there are obvious curing and wire drawing phenomena in the glue solution, it is recommended not to use it, so as not to improve the bonding strength.
2. The glue wave has the smell of acrylate, and it is basically non-toxic after curing. About one thousandth of people will have mild skin allergy, skin redness and mild pain after long-term contact with glue. It is recommended to wear protective gloves, wipe them with acetone and rinse them with water. If solidified on the skin, it will automatically fall off within a certain period of time.
3. This product releases a lot of heat during curing, so it is not advisable to apply glue too thick at one time, otherwise there will be pores in the adhesive layer, which will affect the bonding strength. When it is too large, there is also the possibility of burning due to the intense heat release of the glue.
3. Generally, it can be coated once. In order to prevent the glue layer from leaving pores, the glue should move in one direction and the gluing speed should be fast, so as to facilitate the air discharge and improve the bonding quality.
4. Generally, the thinner the adhesive layer, the less defects and shrinkage, and the higher the bonding strength, the thinner the adhesive layer should be. Thick is easy to cause dryness, stickiness, foaming, etc. Therefore, under the premise of no shortage of glue, the glue layer should be as thin as possible, and the thickness of the glue layer should be generally controlled at 0.08-0. 15mm, that is, the total glue amount is 200-300g/㎡.
4. The curing of this adhesive is greatly influenced by temperature. When used outdoors in winter, it should be supplemented by heating (incandescent lamp, baking and infrared heating), but the temperature should not be higher than 100℃.
5. Be well ventilated when using. Please do not enter the entrance and put it out of the reach of children. Rubber cap should not be covered wrong to avoid deterioration and failure. This product is prone to polymerization and failure when the temperature rises. It can be stored at room temperature (23℃, 2て) for one year, and can be prolonged at low temperature. If it is in the high temperature area in the south, it should be kept in the shade.