What are the methods to cool down the factory building?

1, the factory workshop is equipped with fans, which can be said to be the most economical, fast and practical in the factory. However, in order to better cool down, it is suggested that the die casting workshop keep a high-powered horn fan in front of each machine.

2. Installing a water cooler is more advanced than using a fan and simpler than adding ice. There is no need to buy ice specially. The cost is only a little expensive temporarily, but it will be more practical than the above two. Die casting plants can consider cooling in this way.

3. Add more air outlets to ensure air convection, which is itself a high-temperature working environment. Workshop exhaust device must be in place. Try to ensure that there are 1 air outlets on the side of 2-3 die casting machines on one side of the workshop, and the air outlets on both sides keep blowing.

4, install central air conditioning, good refrigeration effect. At present, many domestic enterprises have installed central air conditioning in the die casting workshop.

5. Increasing the green plant coverage in the workshop and planting or transplanting a certain number of trees in early spring every year can not only increase the probability of natural wind, but also improve the shading effect.

6. The workshop roof is equipped with automatic sprinklers, and the top floor of each workshop is equipped with automatic sprinklers, and water is sprayed several times every sunny day.

7. The workshop roof is covered with insulation layer, which can cover about 10 cm, and can play a certain cooling effect.

Matters needing attention in cooling down the factory building

1, installation area. In order to meet the large-scale refrigeration demand of the factory building, the traditional air conditioner is definitely not suitable, and the installation quantity and cost are unacceptable. Therefore, products with environmental protection, energy saving and wide air supply coverage should be selected during installation.

2. Cooling effect. The refrigeration effect of traditional air conditioners is very limited, and few factories will choose to install traditional air conditioners.

3. Overall price. If the installation cost, operation cost and post-maintenance are comprehensively considered, the traditional air conditioner can basically be eliminated. Although the installation cost and later maintenance cost of traditional fans are low, the coverage of air supply is small, and the cooling effect of large-area factories is not good.