Introduction of wiring clamping method and wiring process of distribution frame

During the installation and operation of some distribution equipment, we may apply it to products similar to distribution frames, which can be used for end-user lines or trunk lines, and can play a role in control and debugging. And it can meet the requirements of coaxial cable, optical fiber, audio and video, so it is widely used and plays an important role. However, there are also high requirements for its installation and operation, such as wiring methods and wiring tutorials, which need to be studied and practiced. These can be referred to as follows.

First, the distribution frame line clamping method

Step 1: Use 5 pairs of wiring tools and 5 pairs of 1 10 wiring boards to clamp the trunk cable to the base of 1 10 distribution frame. The wiring sequence is as follows: white, red, black and Rayna Sue Auxiliary colors: blue, orange, green, brown and gray.

Step 2: In the same way, connect the voice cable with horizontal wiring to the base of 1 10 distribution frame.

Step 3: Use the 1 10 single-pair wiring tool to connect/kloc-0 on the five pairs of 1 10 patch panels above the vertical trunk 10 patch panel and the horizontal wiring 1 0 patch panel as required.

Second, the integrated wiring tutorial

There are two wiring modes of distribution frame, one is called IDC, which is insulation replacement wiring, and generally appears in ultra-five-layer IDC distribution frame. The specific clamping mode is based on its display color code. There is also a modular distribution frame, that is, the distribution frame consists of 24 modules, which can be connected according to the wiring mode of the modules. There is also a color code on the side of the module. On one side, the A/B line sequence is white, orange, orange, white, green and green, and on the other side, it is white, brown, brown, white, blue and blue regardless of the line sequence. Of course, there are also special ones, mainly depending on the color code card connection, mainly using more than 6 types of modular distribution frames.

3. 1 10 telephone distribution frame card?

The design of integrated wiring can be divided into three types: basic, incremental and comprehensive.

Usually, a basic wiring design is used. Therefore, telephone calls are made directly on the 1 10 distribution frame, and network calls are made on RJ45 network distribution frame.

There are usually two situations when using network distribution frame to call voice information points:

1, and the wiring requirement is to increase the design. There is such a requirement in the additional design: each work area has two information sockets, which can provide data or voice access (of course, this requires jumper connection in the management area). In this case, network distribution frame can be used for voice information points.

2, in order to facilitate management. Because there are many pairs of 1 10 patch panels, unprofessional people simply can't understand them. However, if RJ45 network distribution frame is used to transmit voice signals, the port is operational, which is easy for non-professionals to manage and improves the efficiency for professional managers.

The above analysis of the connection mode of the patch panel is easy to understand from three steps. In addition, we also provide reference knowledge for the course of Integrated Wiring, such as its three designs and two wiring methods, which are worthy of reference and also need to be learned by ordinary users and professional technical operators in an emergency. Of course, Bian Xiao also suggested that everyone focus on real life to understand and analyze.