Interview with Stanley Meyer, the inventor of hydropower.
Water fuel cells will decompose water molecules into hydrogen and oxygen, and hydrogen is used to provide driving force, such as rainwater, well water, tap water or seawater. If you really can't find water, so can snow. Because the type of water source has no negative impact on the fuel cell. The cost is about $65,438+0,500 without any maintenance or replacement.
Water fuel injector can decompose water molecules into hydrogen and oxygen. Hydrogen is the power source of cars. Basically, we just need to replace the spark plug with a water fuel cell injector, where we decompose water molecules. When water enters the syringe and comes into contact with high-frequency pulse current, it will decompose immediately. Therefore, we can only drive the car by water.
This equipment can extract hydrogen from water, which is very unusual. Ordinary water will do. The traditional method is called electrolysis. It changes the later stage of electrolysis without generating too much heat. Using zero energy and high frequency voltage. If the standard electrolysis method is used, the water temperature will rise and only last for a few seconds. * * The equipment has been running for half an hour, and the water temperature has not changed. This equipment produces a lot of gas.
This technology can not only eliminate the pollution caused by fossil fuels, but also use water, which can also be used to treat air to activate and maintain the energy level in the atmosphere and restore it to its original level.
The inventor of the carburetor, using the carburetor, can make the car run 200 kilometers per gallon of fuel, but his technology has not yet appeared on the market.
In order to make our economy rely on fossil fuels.
Principle: Reduce the current, expose water molecules to the opposite voltage, and negatively charged oxygen atoms are attracted to the positive voltage. This is the principle of physics. Opposites attract, and positively charged hydrogen atoms are attracted by negative voltage, so you overcome the theoretical difficulties. In the process of attracting charged water molecules, you will cause the water molecules to expand and split. When appropriate, turn off the valence bond of water molecules. Now, you can get hydrogen and oxygen from them. This is essentially a physical process, not because you use electronic circuits and field potential energy. This is a physical process of voltage modulation. Dry electrodes attract each other first, so when you release hydrogen and oxygen atoms, you can use them. The energy of hydrogen atom is 2.5 times that of fuel oil. How to achieve it without consuming a lot of electricity? This is using VLC circle, and this is its job. We have created a vibrating cavity, because natural water is a dielectric insulator. .
When I fill a buffer between two electrodes, what model is this? What if I don't do this? Now, if I put a set of coils in * * and * *, a * * * vibration enhancement cavity. We can prepare the pulse. You need to convert the voltage of 12V into the voltage of 20000V, and when you impact here, a ring magnetic field is generated. This magnetic field will stop the movement of electrons. Because of the inductance and capacitance of the coil, now you can pressurize the cavity, adjust the voltage and shape it to 90 degrees. Even if I design the pulse degree like this, adjust the properties of water, adjust the current to the minimum, and adjust the potential energy to infinity, if electronic components allow. In the process of power generation, there are two stages. Electric current will consume electric energy, and then you have potential energy. If the current is limited, what will be left? Try not to consume potential energy in the current and electronic circuit, and let it become a kind of potential energy. You can use this energy to complete the work. We found that because the instantaneous voltage can be increased, hydrogen and unproductive substances have a linear relationship with the current, because we limit the current, so we can get exponential output, high voltage, and then there will be a lot of hydrogen. Here, we also found an interesting phenomenon. We reduce the amplitude according to the pulse step, and we operate this oscillation process to start the charging process. When we started to reflux, we found that when we turned off the charging, we could keep running for 5 seconds with * * * vibration and then cut it off. We can make hydrogen for 94 seconds. So, if you use 94/5, we will produce 19 times of hydrogen. Isn't that amazing?
If the pipeline is arranged along a straight line, the incombustible gas will be separated from oxygen atoms and hydrogen atoms. Now you will understand the laws of physics. One condition is that hydrogen and oxygen cannot be mixed together. If we separate them, then * * * *?
The United States controls most oil-producing countries with dollars. In order to maintain the hegemonic position of the dollar, it is impossible to let such things exist. 300 countries. The country signed a secret agreement and can know this without using hydrogen. ...
A friend of mine made a similar one, about the size of an aluminum can, with a lamp on it, about 50 A, which still lights up, but it still needs a 3A battery power supply device. The principle is similar to the above, but it also uses electrolyzed water, but it doesn't need so much power, and the process of generating hydrogen is not too high, even a little cold. My friend mentioned two key points, one is the material for producing hydrogen-oxygen rods, and the other is the frequency. A friend installed a thin tube, then lit the needle for injection with a lighter at the other end, and a blue flame came out. This technology is not difficult. What is difficult is the wall of human thinking.