The pin is mainly suitable for being fixed on the wrist and can be used at any time. Bead needle, a special needle for draping, has a long and slender needle body, which is easy to penetrate into multi-layered fabrics.
Use bead needles to fix the fabric on the mannequin in two ways. The first is a single pin fixation, which directly fixes the fabric on the mannequin, and the second is a cross fixation, where two pins fix the fabric together. The method of pin fastening is the overlapping method. The first one is to use a pin to pass through two pieces of gray fabric at an angle to pin the gray fabrics together. The second one is to fold part of one piece of fabric, then cover it on another piece of fabric, then use a pin to pass through the three layers of fabric and pin the two pieces of fabric together.
The prototype is the most basic and simplest paper pattern, and is the basis of all styles. The draping prototype is the basis for draping the garment body. The steps are as follows: 1. Determine the front center line, bust line and reference line and cover the mannequin with fabric that matches the same name line on the mannequin. Use pins to fix the front center line and B.P point on the mannequin. 2. Push the excess amount below the bust line below the B.P point to form a waist dart and fix the waist dart with a pin. At the same time, determine the position of the side seams and fix them. 3. Push the excess above the bust line to the shoulders, and make cuts at the neckline to eliminate the pulling force at the neckline. Make dotted lines on the fabric based on the basic lines of the collar, rotator cuffs, and holes. 4. The operation method of the rear piece is the same as that of the front piece.