Printer feed steps:
1. Open the paper feed box. Find the slot hole of the printer paper inlet and pull out the paper inlet box.
2. Adjust the left, right, front and back widths of the paper tray guide. The guide plate is used to adjust the size of the paper feed box. The width of the guide plate of the paper feeding box is divided into left-right width and front-back width, and the widths of the left-right and front-back guide plates slide to the outermost side respectively until they stop at the outermost side.
3. Add a proper amount of printing paper. Unpack the printing paper and take out a stack of printing paper. Don't add too much at a time. Adding too much will lead to printer paper jam and other faults.
4. Printing paper is stacked symmetrically, waiting to be added. Tidy up the printing paper before adding it, and put it into the paper box after the water chestnut is symmetrical.
5. Adjust the guide plate according to the paper width. Slide the widths of the left and right guide plates and the front and rear guide plates near the printing paper respectively until the guide plates slide to the edge of the paper. Check whether there is a gap between the paper and the guide plate, and it is best not to leave a gap.
6, slowly close the paper feed box, don't push the paper feed box, causing the printing paper position to move.
7. Make a form, print it out, and check whether the printing paper is put correctly. Making tables with word. Print it out to see if the border lines of the table are neat.