1. Put the rubber sleeve on the inflation nozzle and pull the inflation rod to inflate the balloon. By constantly twitching and pulling back the handle of the inflation rod, the balloon can be inflated to a suitable size.
2. Put down the inflatable wand. At this time, one hand holds the ball mouth and the other hand pulls the ball mouth, which is about 5-7 cm long.
3. At this time, the left hand stretches out the thumb and forefinger, and the right hand pulls the glue mouth, bypassing these two fingers, and then pulls the glue mouth to the middle position after a turn.
4. Release the ball mouth with your right hand, and clamp the ball mouth with your left index finger and thumb. The two fingers holding the ball mouth shrink backwards, and then the ball mouth will be naturally brought over to complete the knotting operation.
Don't think it's over. Remember not to pull the ball directly at this time, because pulling the ball at this time is most likely to puncture the balloon at the knotted place, resulting in air leakage. Therefore, it is necessary to hold the place where the ball is knotted with one hand and pull the ball leather with the other hand, which is the real completion of the knotting operation.
6. If you need to use a lot of balloons at a time, you can tie the balloons with the clothes rack at home, erect the clothes rack, then extend the balloon mouth around the clothes rack, and pull it inside to tie the knot, which will not hurt your hands at all, simply and quickly.