The process of making electronic cigarettes is as follows:
1. Production of atomizing head
Heating wire: 0.12mm, 2080 specification tweezers chromium heating wire, resistance The value is 2.5~3.0 ohms, and the length depends on the resistance, usually 55~60mm long. High-temperature wire, 0.2~0.25mm, with insulating rubber, 0.4~0.5mm, the length depends on the hardware structure
Fiber rod: resistant to high temperature, can absorb oil, also called oil-absorbing cotton, depending on the size It depends on the structure of the ceramic base and the specifications of the heating wire.
Wrap the heating wire around the fiber. Place the wound heating and fiber rods into the ceramic. Cut the two high-temperature wires into two pieces. Cut the heating wire into lengths as required. The seat should not be too loose. Lead the high-temperature wire from the bottom of the ceramic seat. Don't solder the two ends of the heating wire to determine the resistance. Twist the high-temperature wire. Avoid welding a high-temperature wire. Put the nut and silicone in it and thread the high-temperature wire through it. Insert five to avoid contact with the pins. Connect to the upper side piece of the pins and fix a layer of circular tweezers mesh. The pins surround the ceramic base and fix the fixing piece on the ceramic base. Burn another high-temperature wire in a circle and weld both sides of the tweezers mesh to the nut. To test whether there is a short circuit/open circuit on the inside, gently press the ceramic seat and the tweezers mesh into the outside of the nut, fold the slender rectangular tweezers mesh, and check whether the resistance value is normal. Inside the steel pipe, press it on the fixed piece from the bottom up.
2. PCBA production
Weld two long wires and a short one. Check the appearance of the lightning flash three times/switch and turn on the peripheral special inspection. Open the patch test, cut the wire, and The length depends on the long working time of the battery/charging/other testing of the LED light and the completeness of welding. The wire diameter is 0.5mm. The performance test is connected to the welding of the motherboard
3. Cartridge production
Put the shredded tobacco into the middle of the inner shell of the cigarette holder, add appropriate amount of e-liquid, and hot-melt it with tin foil paper into the cigarette holder shell
IV. Production of the finished product
Pull out a positive pole from the battery Connect the wires to the circuit, connect the pins and screws to the circuit board, secure one of the pins to the circuit board, secure the screws with the silicone sheet, and put an insulating film on the positive end to weld the positive wires respectively, and fix the negative pole of the welding plate with a screw. Pin installed.
/p>
Put the screw lightly on the mouth of the pipe, take a sip, and test whether the LED light is on. Press the screws into the steel pipe and use a tester with an atomizer head to check if the packaging LED light is on. Otherwise, check whether the circuit is normal. Use a good cigarette cartridge with an atomizer head to test. If there is smoke, if there is no smoke, the cigarette is in good condition. Bomb test to see if there is smoke or check if there is no smoke.
E-cigarettes are also known as virtual cigarettes and electronic atomizers. They have the same appearance as cigarettes and a similar taste to cigarettes. They even have many more flavors than ordinary cigarettes and can be smoked just like cigarettes. .
Put out smoke, smell and feel. Mainly used to quit smoking and replace cigarettes. It is a non-combustible electronic cigarette. Its effect is similar to that of ordinary cigarettes. It can refresh people, satisfy their craving for cigarettes, and make smokers happy