Metal pipe cutting machine under 2 inches
Metal pipe cutting machine ECG2, which is less than 2 inches, is a professional cold cutting tool for cutting cast iron, carbon steel and stainless steel pipes produced by E-WORK. This machine adopts spring guide frame, so that the four blades walk in a line and the incision is straight. The thin and sharp blade is made of high-strength tool steel, which saves labor and cuts quickly. It is a pipeline cold cutting tool with high cutting speed on the market at present. Because the blade is sharp and cutting is more labor-saving, the handle of the pipe cutter can be designed to be shorter, which is very suitable for operation in a narrow space.
Metal pipe cutting machine under 2 inches
Operating steps:
1. Check the blade to ensure that the blade is suitable for the type of pipe to be cut.
2. Place the pipe cutter vertically on the pipeline, and the four contacts of the two elastic positioning claws should be evenly contacted on the surface of the pipeline. Tighten the handle so that the blade contacts the pipeline vertically, and the cutting depth can be less than 0.5mm..
3. After the pipe cutter rotates slightly, make sure that the cutting track is on the circumference (otherwise, loosen and reposition).
4. Swing the operating handle of the pipe cutter back and forth between 90 and140, and constantly tighten the operating handle for feeding (as long as the pipe cutter can rotate, the tighter the handle, the better).
5. Swing the handle back and forth and feed continuously until the pipeline is cut off.
Note: When cutting pipes, adding lubricating oil at the knife edge can not only save labor, but also prolong the life of blades and equipment.
Rotary pipe cutter
Rotary pipe cutter series products are a series of professional cold cutting tools produced by E-WORK for cutting large-diameter carbon steel, stainless steel, cast iron and ductile iron pipes. Ultra-reasonable fuselage design and ingenious structural setting make pipe cutting faster and more labor-saving! The cutting blade is made of high strength tool steel. After special heat treatment, the strength and toughness of the blade are balanced, which not only ensures the rapid cutting of the blade, but also ensures the long-term wear resistance.
Rotary pipe cutter
Operating steps:
1. Check the blade to ensure that the blade is suitable for the type of pipe to be cut.
2. Ensure that the rod end connected by bolts is in a proper position, which is suitable for the size of the pipeline to be cut. Loosen the turnbuckle evenly until the distance between the center of the rod end eye and one end of the turnbuckle is about 57 mm (2 1/4 inch). Open the release pin and connect the pipe cutter to the pipe to be cut. (If the clearance around the pipe is very small, you may need to untie 2 pins. Connect the release pin in place through the yoke part and the rod end, and place the spring-loaded guide part of the pipe cutter above the pipe. Tighten the two turnbuckles evenly by hand until all four cutting wheels touch the pipe. Tighten the turnbuckle every time the pipe cutter rotates 1/2 times. You can also use the turnbuckle to push the pipe cutter around the pipe.
3. While pushing the pipe cutter around the pipeline, tighten the turnbuckle as much as possible. (If sufficient tension is provided, the handle lever can be easily tightened by 0/2 turn of -65438+ turnbuckle.)
Articulated pipe cutter
Articulated pipe cutter series products are a series of professional cold cutting tools produced by E-WORK for cutting carbon steel, stainless steel, cast iron and ductile iron pipes. Ultra-light body design and reasonable structural setting make the cutting performance more superior. The cutting blade is made of high strength tool steel. After special heat treatment, the strength and toughness of the blade are balanced, which not only ensures the rapid cutting of the blade, but also ensures the long-term wear resistance.