1. performance parameters of electronic mousetrap: input voltage: ~220V frequency: 50Hz output voltage: 1800V.
No-load current: ≤ 40mA; Mouse catching current: ≤32mA.
Second, the working sequence of the electronic mousetrap: after the mouse touches the high-voltage line, the mouse body can't stand still, and the TYDZ-3 electronic mousetrap gives an alarm for a long time, and the mouse body sticks to the high-voltage line, so it needs to be removed manually. Long time does not rule out the disadvantage to the service life of mousetrap.
3. Principle of electronic mousetrap: When the mouse touches the high-voltage conductor, the high-voltage current passes through the mouse and forms a loop with the earth. The acousto-optic alarm circuit of the mousetrap is driven by the high-voltage current of the mouse to send out an alarm signal, and at the same time, under the action of the high-voltage current, the whole body of the mouse can't move and suffocate. The red, yellow and green colors of three high-voltage lines output by TYDZ-3 electronic mousetrap correspond to the red, yellow and green indicator lights on the mousetrap respectively, which can control three mousetrap areas.
Fourth, the application experience promotion: 1, the electronic mousetrap is suitable for any area; 2. Indoor rats can be killed only by blocking their drinking channels for 3-6 days without moving a lot of articles and wires; 3. When catching rats on dry ground and cement ground, water along the line, but pay attention to cut off the power supply when watering, and do not pour it on the insulating tube; When catching rats on the wooden floor, a metal plate should be laid under the high voltage conductor, and the grounding wire should be connected to the metal plate; 4. The bare wire of the mousetrap must be insulated with plastic pipes and tied to the bracket (such as bamboo sticks and nails), otherwise it may be short-circuited and broken down, thus damaging the mousetrap; Note: the diameter of the bare wire for catching mice is preferably between 0.3 mm and 0.5 mm. Everyone knows that it is myopia. If you find a mouse with too large a diameter, it will affect the effect of catching mice. 5. Don't pull the high-voltage wire for catching rats on the slope that is too inclined, in case the rats can't catch the thin wires and break back to life after being fainted by electric shock; 6. When laying the high-pressure rodent control line, make preparations several hours in advance, and the rodent activity is generally around 17-20; 7. Don't turn on electricity when you don't plan to kill rats, so that rats can get familiar with the environment and kill rats more easily, and there will be no freshness and fear. 8. Rats are very sensitive animals. When dealing with dead rats, it is best to stay away from the rodent control site. You should deal with one at a time, don't shout.
Verb (abbreviation of verb) Note: 1. The high-voltage lead wire for catching mice must be tightened, and it is advisable for mice to press the lead wire without touching the ground, otherwise the current will be reduced and the mice may escape. 2. When rats pass through the pedestrian passage, insulated wires can be used instead of high-voltage wires to catch rats. It will be very uncomfortable for the human body to touch the local area by mistake, but it will not cause danger to people and small animals over 0.5 kg, because we have limited the current to a safe range. 3. Users can't change the current limiting device and key components without authorization (because the key components are not available in the market, they are customized by our factory and cannot be replaced). If the current limiting device is damaged, users can easily burn out the mousetrap, which is also harmful to human body.