Some washing machine screws may be at the back, so you can lift the front to tilt it. It's mainly the wire at the back. Don't break the power cord.
3. After loosening the screw, push it forward slightly, and the panel can be picked up against the wall.
4. Disassemble the pulsator with a large cross or flat screwdriver, unscrew it and take it out of the barrel. There is a washer under the pulsator.
5. Remove a big nut. It is recommended to find a special tool, otherwise the whole barrel will fall down if it is not tightly packed in the future. Be sure to tighten it when you put it back. The tighter the better.
6. Remove the nut, and there is an L-shaped fixing sleeve under it, so you can't lose it.
7. Then the whole bucket can be taken out.
Extended data
Skills in cleaning process
1, the drain pipe must be higher than the drain pipe, and no water can be left in the drain pipe.
Take the clothes out to dry immediately after washing, don't stay indoors.
3. Store in a ventilated and dry place, and avoid storing in the bathroom.
4. When not in use, take down the filter bag and hang it outside to let it dry fully.
5. After washing clothes, be sure to drain the water in the washing machine and open the lid to dry, so as to prevent the residual water from forming a breeding ground for microorganisms in the machine.
6. After the top door washing machine is used, dry the water inside with a dry rag. In addition, the washing machine with a side door should dry the water embedded in the gasket beside the door to avoid breeding mold.
7. It is best to flush the drain pipe with clean water after each use.
Baidu encyclopedia-washing machine