The suction cup bracket of mobile phone is a suction cup type mobile phone bracket. The mobile phone bracket is fixed on the front windshield or other parts of the car through the sucker installed at the end, and the mobile phone is fixed through the clip at the front end. The use method of the sucker mobile phone bracket is simple:
Install the sucker bracket first, then wipe the front windshield or the position where the mobile phone bracket is to be installed with a wet paper towel, and then dry it with a paper towel; Then tear off the protective film of the sucker and install the sucker on the car; Finally, put on the mobile phone and adjust the angle of the sucker bracket so that the driver can easily see the screen of the mobile phone.
Second, is the suction phone bracket easy to use?
Suction cup mobile phone bracket is a conventional car phone bracket. Its advantage is that the driver can easily observe the screen of the mobile phone. A good sucker bracket has strong suction force and high stability, and it will not shake off even if the car is driving on a bumpy road, which is very convenient. However, the suction cup mobile phone bracket also has some shortcomings.
There are three main disadvantages of the sucker bracket: First, the sucker bracket will block the line of sight more or less, which will have a certain impact on driving safety, which is inevitable; Secondly, after the sucker mobile phone bracket is removed, it will leave the imprint of the sucker, which is difficult to remove if it is not cleaned in time, which may be unacceptable to people with cleanliness; Another disadvantage is that the quality of the sucker bracket is poor, or the suction becomes smaller after a long time of use, which may shake off because of road bumps.
Generally speaking, the suction-type mobile phone stand is convenient, but it has certain security risks, and there is a risk that the mobile phone will fall. There are many kinds of mobile phone brackets in the car now, so it is not recommended to choose this bracket.
Third, what should I do if the suction cup mobile phone bracket can't suck?
After using for a long time, the suction force of the vehicle-mounted suction cup bracket may decrease. The treatment method that the suction cup of the vehicle-mounted mobile phone bracket cannot be adsorbed is as follows:
1, rinse with water, gently wipe with soap bubbles, and dry before installation.
2. Wipe the attached glass surface clean, and dry it after the chassis is slightly wet. Pay attention to let the bottom rest on the center console.
3. Choose thick sponge-like double-sided adhesive.
4. Put some water on the sucker, or smear egg white on it to increase suction.