After setting the step sequence, press "Step Sequence Setting" and "Enter" to set the step sequence data. After setting the corresponding parameters, press "Enter" to enter the next parameter.
1. Setting the winding start point means setting the winding start position.
2. Width is the width of flat cable.
3. The wire diameter can be determined according to the width/turns, or it can be slightly reduced according to the actual wire diameter, so that the wire arrangement will be more compact.
4. The number of turns is the number of turns to be wound according to the document requirements.
5. Normal winding speed at high speed
6. The low speed needs to be set by winding the local train and stopping the local train.
Some processes that can be applied to high-frequency transformer winding machines are as follows:
1. Cover the retaining wall with adhesive tape;
2. winding;
3. Interlayer tape.
The above steps are basically repeated. Numerical control winding machine can set the initial winding position (winding point) of the product, the width (width) of the cable, and the cable diameter can be tightly wound, loosely wound and wound. According to actual needs, input parameters (wire diameter), winding turns (total turns), other speeds and no-load trains are all control parameters.