How to install the toilet flange What are the steps to install the flange ring?

Many people have this problem. When the toilet is used for a long time, it sometimes leaks and gives off a bad smell. In fact, this may be the reason for the long-term failure of the toilet flange ring. It will take some time for the maintenance master to repair it, so it is better to do it yourself. Next, I will tell you how to install the toilet flange and what steps are taken to install the flange ring, so that everyone can easily solve the problem of water leakage in the toilet at home.

The flange ring (or flange ring, toilet sealing wax ring) at the bottom of the toilet is a gasket made of wax and placed on the ground. Installing flange ring can not only save money, but also solve the leakage problem of toilet and avoid causing greater losses. However, during installation, please make sure to operate at a temperature above 2 1 Celsius. Why? Because the wax at this time is easy to bend for installation. In addition, remember to wear plastic gloves before replacing the leaking flange ring of the old toilet.

The steps are as follows:

1. First, make sure to close the water valve (the water valve at the toilet or the main water valve).

2. Rinse the water in the water tank and bedpan.

3. Drain all remaining water from the water tank and bedpan. This can be done with a thick towel or sponge.

4. Remove the nut cover that fixes the bedpan base to the ground.

And unscrew the nut. At this time, it may be necessary to use lubricating oil and vice. 5. Disconnect the water supply pipe.

6. Gently shake the toilet back and forth to loosen the wax sealing ring and glass. Be careful with the bedpan, not the water tank. If you grab the water tank, you may damage the joint between the water tank and the bedpan or crack it.

7. Remove the old wax sealing rings on the two joint surfaces.

8. Disassemble the new flange ring (available in the hardware store) so that its round edge is up and put it on the flange on the ground so that it is just above the opening. Make sure that the two screws are in place.

9. Lift the toilet, put it on the flange and wax sealing ring, and try to keep the toilet level.

10. Sit on the toilet to help seal the new flange ring and ensure that the bedpan is level.

1 1. Reinstall the nut just removed. Tighten the nut by hand to prevent the bottom of the toilet from cracking.

12. Reconnect the water supply pipe.

13. Open the water valve to fill the water tank.

14. Rinse and check for water leakage.

15. If necessary, apply glass glue between the bedpan and the floor.

16. You're finished! It's not difficult anyway. Finally, remember to wash your hands with hand sanitizer.

The above are the steps and methods of installing the toilet flange ring. Actually, it's not as difficult as I thought. It's enough to practice a few more times.