How to use the manipulator of the punch safely?

The manipulator of the punching machine can simulate some movements of human arms, grab and carry workpieces or manipulate tools according to the requirements of predetermined procedures and trajectories. Manipulator can replace a lot of repetitive physical labor, thus reducing the labor intensity of workers and improving production efficiency. But now how to produce safely is also a compulsory course for enterprises. Boris introduced to you today is a manipulator manufacturer of punching machines (ask Boris if necessary). Due to the characteristics of high speed and high pressure, certain safety regulations must be observed when stamping with a punch.

1. The transmission parts exposed to the outside of the press must have a protective cover, and it is forbidden to start or test run with the protective cover removed.

2. Before starting the car, check whether the main fastening screws are loose, whether the mold is cracked, whether the control mechanism, automatic stop device, clutch and brake are normal, and whether the conflict parts between the manipulator parts of the punch press and the lubrication system of bearings, sliders and other parts are blocked or lack of oil, and regularly clean up the dust on them; You can drive an empty car to test if necessary.

3. When installing the die, the manipulator manufacturer of the punch press must open the slider to the bottom dead center, and the closing height must be correct to avoid eccentric load as much as possible; The mould must be firmly fixed and checked by pressure test.

4. Before adjustment and maintenance, please turn off the power supply of the ejector and the manipulator, and release the residual pressure of the manipulator. Pay attention to work, and it is forbidden to put hands and tools into the danger zone. Punching manipulator, small parts must be operated with special tools (tweezers or feeding mechanism). When the mold is stuck in the blank, only tools are allowed to release it.

5. If abnormal operation or sound (such as combo sound and crackle sound) of the printing machine is found, the paper feeding should be stopped and the reason should be checked. If the rotating parts are loose, the control device fails, the mold is loose and defective, the machine should be stopped for repair.

6. When cleaning each workpiece, hands or feet must leave the button or pedal to prevent misoperation.

7. When two or more people operate, they should drive by themselves and pay attention to coordination. Before coming off work, close the mold, turn off the power and clean it as necessary.

Stamping accidents may occur in all kinds of dangerous parts of stamping equipment, and it is very important to operate the mechanical arm equipment of punching machine correctly for production. Stamping operation has the characteristics of great danger and frequent accidents, and the injuries caused by accidents are generally serious. At present, there are many kinds of safety technical measures to prevent stamping injury accidents, but the operators must have a certain technical level and the ability to identify various dangers in operation. Safe operation and production of the manipulator of the punching machine.