1. Positioning
The accuracy of line drawing positioning is related to the success or failure of curtain installation. First, measure the fixed hole spacing and the size of the required installation track.
2. Install curtain rails
1. Curtain rails can be single, double or triple. When the window width is greater than 1200mm, the curtain rail should be disconnected, and the bends at the disconnection should be staggered. The bends should be gentle curves, and the overlap length should not be less than 200mm. Ming curtain boxes usually install the track first. Heavy curtain rails should be installed with machine screws; dark curtain boxes should be installed with rails at the back. The small corners of heavy curtain tracks should be closely spaced, and the size of wood screws should be no less than 30mm.
2. Install the lifting clips, rotate the clips 90 degrees to connect with the track, and use self-tapping screws to install the lifting clips on the top plate. If it is a concrete structure, expansion screws need to be added.
3. Install the curtain rod
1. Correct the connection fixture, install the rod or wire, and pull it on the fixture. Make it flat and consistent with the elevation of the room.
2. Install a standard curtain track (double track), the basic width should generally be above 15CM, and the single track can be reduced according to appropriate circumstances.
4. Adjust the position
For floor-standing curtains or curtains that hang over the countertop, the track should be installed to allow for the width of the window sill to prevent the curtain from being blocked when drooping and looking unsightly.
5. Pay attention to the wall surface that is actually attached
It is required not to be hollow, otherwise the veneer will easily burst when drilling.