Firstly, the function of interior wall plastering is introduced.
1. To operate the automatic plastering machine, only two Zhi Zi and traditional dotting are used to locate on the working wall, which solves the problem of difficult positioning and large error, and keeps the working wall on a horizontal plane all the time, thus ensuring the accuracy of the whole working face.
2. The working face plastered by the automatic plasterer has high quality: the whole working face has no ditch marks. The angle of yin and yang in plastering face is naturally formed, and the plastering face is firm.
3. The machine has strong adaptability: it can be used for the operation of sand ash, white ash, cement ash, dry powder mortar and foam mortar, and can achieve the high precision required by the state.
4. There is no ash leakage and falling in operation, which is easy to maintain and carry.
Secondly, the characteristics of interior wall plastering are introduced.
1, automatic walking (this machine is small in size, light in weight, convenient to move, designed with automatic walking function, easy to operate, and greatly saves time and effort.
2. Automatic positioning (a set of positioning device independently developed by our company and matched with plastering machine (which has applied for national patent), combined with laser positioning and vertical instrument, has truly reached the precedent of automatic operation of plastering walls at home and abroad, effectively ensuring the accuracy of wall flatness and verticality).
3. Automatically adjust the plastering thickness (the plastering thickness can be automatically controlled, and the adjustment range can be arbitrarily run between 2mm and 5cm to ensure that the plastering thickness is not less than 3cm at a time).
4. Automatically adjust the secondary plastering joint (the adjustment range is 2mm——5cm, and an automatic plastering device for the secondary plastering joint is designed to ensure that no trace is left on the joint).
5, suitable for internal and external wall mortar, cement mortar, lime putty, cement thinner smoothing and calendering.
6. The width of plastered wall is 0.3- 1 m, the height is below 4m (user-defined), and the diameter of stud is 48 mm. ..
Third, the use of interior plastering machine
1, spraying, feeding the mortar machine, adjusting the proper mortar consistency, and spraying. The spraying thickness is generally 2 cm higher than the wall surface. The specific requirements are as follows: the nozzle should be sprayed according to the condition of the wall surface, and the wall surface should be as flat as possible; Guide the nozzle to move back and forth at a uniform speed in the horizontal direction, and circumferential injection is not allowed; When spraying wall mortar, be sure to make the nozzle slightly upturned, otherwise it will always be sprayed on the wall at right angles; The distance between the nozzle and the wall should be 10 ~ 30cm.
2, screeding, mortar spraying is completed, need to immediately screeding construction, with a big scraper along the wall from bottom to top, scrape off the material in the depression, try to do a rod screeding. If the mortar is thin, it is not suitable for leveling immediately. After the mortar is slightly hard, check the flatness of the wall with a 2-meter-long board. Scrape high, low to make up, rub with a small foam washboard.
3, calendering, calendering time to hand pressure mortar, fingers no longer sticky mud, with foam board dipped in water for calendering, calendering with a smooth iron trowel, until the surface is smooth and flat.
Friends, these contents are what I told you about this indoor plastering machine, what it is, and what its functions and characteristics are. Friends have got a general idea of it, and the steps of using our indoor plasterer. Friend, if you want to know other decoration information, just pay attention to us.