Can you see nail holes on the surface of customized wardrobe?

No, three-in-one fasteners and two-in-one fasteners are commonly used in custom wardrobes. During factory production, the fastener eyes are all on the side of the board, and they are basically invisible after installation. The so-called eye of a needle should be the nail eye used by traditional carpenters to hit cabinets. Traditional carpenters hit cabinets and cut boards on the spot. Only nails can be used to install and link boards, so it is difficult to avoid nail holes.

Command attention

The wardrobe must be top-notch, reduce the sanitary dead angle and be beautiful.

To be a top wardrobe, note:

1. Determine the width and height of the wardrobe in advance.

2, completes the wall leveling.

3. A straightener is installed in the cabinet to avoid the deformation of the cabinet door.

4. Add a sealing plate of about 1-2 cm from top to bottom, and the overall effect from one door to top is good.

Distinguish the true and false materials of solid wood wardrobe

1, look at the surface texture and scar.

All solid wood wardrobes have natural chromatic aberration, and the color and texture are different to some extent. The wardrobe with solid wood veneer has fewer appearance defects and clear texture, which is even better than the all-solid wood wardrobe. Consumers can use the texture and scars of solid wood to see the corresponding position of the outside and the back. If the corresponding position is good, it is a pure solid wood door. In addition, looking at the scar section is also a good way to identify pure wood: look at the position of one scar and then find the corresponding texture on the other side.

2. Observe the cross section of the wood.

For the identification of wooden boards combined with wardrobes, it is generally a large area of artificial boards such as wardrobe frame, laminated board and drawer inner board. If the manufacturer sticks solid wood skin outside the artificial board, although the surface is smooth, the durability will be improved, but in the cross section of the board, two faces will be found facing the grain, which is not in the normal growth direction of the tree. This is the main identification method.