Drill holes in the wall with special tools. The baseboard is generally 2m in length. In order to make the skirting board fixed more firmly, the spacing of drilling holes should be about 40cm, and the spacing at the interface should be smaller. The baseboard nails the small wooden strips into the holes just punched. The nail that fixes the baseboard is nailed to this batten and directly nailed to the wall, so the nail is easy to loosen.
Note: Because the pipeline of hydropower project is buried in the wall, the position of the pipeline is directly below the switch socket, so the position should be calculated when drilling to avoid damage.
Fixing: Before fixing the skirting line, the wall should be leveled and cleaned, otherwise the skirting line will not completely fit the wall after installation, leaving an ugly gap.
Look at the location of the hole, and then fix the nail on the skirting board. When fixing, pay attention to whether the skirting line is close to the wall, and the nails should be completely submerged in the skirting line and invisible.
Note: the skirting made of polymer, density board and wood has the characteristics of thermal expansion and cold contraction, so the skirting near the corner should be like the floor, leaving an expansion joint of about 1cm.
Corner treatment: At the intersection of corner and skirting line, the edge of skirting line should be cut at a 45-degree angle, so that the interface will not leave ugly marks. Fix the cut baseboard. Note: the skirting line at the corner must be cut at a 45-degree angle before splicing and installation, otherwise it will affect the appearance.
Key points of installation: Use special threaded nails to fix the baseboard, so that the fixing effect is better and it is not easy to loosen. Everyone should pay attention to whether the manufacturer has cut corners.
The baseboard was originally designed to cover the expansion joints of the floor and make the floor more beautiful. Therefore, the edges where the skirting lines intersect should be leveled with a plane.
The skirting line should be completely close to the wall without leaving gaps, which is more beautiful, especially in the corner. Before installation, the flatness of the wall should be tested.
Composition and structure of aluminum alloy substrate;
Aluminum alloy baseboard adopts national standard 6063-T5 aluminum. The hardness of the alloy is (13- 15) degrees, the service life is (3-5) times that of ordinary aluminum, and the yield strength can reach more than 500Mpa. The product is shaped by a series of special processes, the surface of the product is tapped with a straight line, and then colored and oxidized at high temperature. The aluminum alloy skirting line produced from this aluminum has the advantages of strong texture, colorfastness, high strength, no deformation, waterproof, moisture-proof, anti-collision, insect-proof, moth-proof, wear-resistant and aging-resistant, safe and environmental protection, simple installation, convenient disassembly, wiring function and reusability. This is something that all kinds of materials can't do in the past.
The aluminum alloy ground wire is a personal patent product, which is characterized by comprising a first aluminum alloy strip, a second aluminum alloy strip and a connector, wherein the splicing ends of the first aluminum alloy strip and the second aluminum alloy strip are respectively provided with slots, and the cross sections of the slots are U-shaped; Both ends of the connector are respectively provided with a first insertion part and a second insertion part, which are respectively inserted into the corresponding slots through the insertion ends of the slots, and the first insertion part and the second insertion part are respectively matched with the corresponding slots. The aluminum alloy grounding wire of the utility model is simple in structure and easy to manufacture. The upper parts of the inner walls on both sides of the slot are provided with inward protrusions, and the corresponding first insertion part or second insertion part is clamped between the inner bottom surface of the slot and the protrusions, so that the clamping ability is strong and the plugging performance is good.