Finishing system
Ensure that the light steel drum adopts progressive finishing system, so that the finishing system can be added to the flat end of the product, with good light steel keel wall, light weight and low signal confirmation.
Strong serrated root
Products should have solid serrated roots as raw materials, and continuous hot gypsum board can make weeds on both sides reach or exceed the national level.
Reach the relevant domestic level.
The product ratio is remarkable, which is in line with the relevant domestic level: the top-to-height ratio is high, the highest height is higher than the national average, and the inertial mass is high. The key, structural sustainability and suitable structure are put forward.
Strong research and development capabilities
Developers should have strong research and development capabilities. The producers of steel light kelp products should have patented products such as ch keel, Z-shaped sound keel, concave-convex drum and compound ridge, which are suitable for other special needs.
distribution line
According to the design and structure of grounding belt, grounding belt or precast floor slab, the wall line, front door line, window and windowsill line are set out. Set the high white edge.
Door frame at the door
Door frame entrance hole: after laying the wire, enter the wall to open the door as designed.
Ridge layout
Place the ridge above and below the ground. According to the installation line of the separation wall, the top of the column and the soil ridge are placed. Use the feathered front door.
Make beads
Direct bead making: according to the opening of the front wall entrance, the height is set to 900 mm or the cover height 1200 mm, and then the size of the cover is fixed. 450 mm subdivision and module and module subdivision should be avoided. The covering on the first panel at the end of the threshold means that the gypsum covering is not in the threshold.
Insert rear roller
Insert the rear drum: insert the nail ridge according to the position of the equipment. Enter large paper and vertical bottom, and then return to the ground. When you change the position and position of the line, add it to the throne. Its speed is 1000 mm, and it is connected to a wall or a post.