All the screws on the rear cover of the Savior need to be unscrewed.
Except for the two screws in the upper left corner and the upper right corner, they are the two screws next to the foot pads.
Then slide the cover down to open
Align the memory gap and insert the memory into the memory slot at a 45 degree angle, and use force to ensure that the memory is inserted in place
, and then press down, you will hear two clicks. If you are worried
you can lift the memory and make sure the buckle is in place. Then turn on the phone without closing the back cover
Test if the machine lights up normally and the system recognizes the memory. Shut down and close the back cover.
First prepare the disassembly tools (including screwdrivers and picks); shut down the Lenovo Rescuer y7000 and unscrew all the screws on the back cover; use the picks to start from the edge of the bottom cover and slowly move clockwise. Pry open the bottom cover; after removing the back cover, you can see the battery and hard drive inside the host. Unplug the battery cable and remove the battery by unscrewing the screws that secure the battery. The specific introduction is as follows:
1. Before disassembling the Lenovo Savior Y7000 battery, you need to do an anti-static treatment and prepare the screwdrivers, picks and other tools needed for disassembly;
< p>2. First make sure that the computer is completely shut down, then turn the computer over and remove the screws on the back. There are 11 screws in one. There are two long and short screws. Pay attention to place them accordingly;3. Disassemble After removing the screws, use a sled to start from a point (such as the two corners on the front of the notebook body) and slowly pry open the bottom cover according to the direction, being careful not to break the plastic buckle of the body;
4. After taking off the back cover, you can see the battery and hard drive inside the host. The battery is in the lower right corner of the fuselage. Disconnect the battery cable first, then unscrew the screws that fix the battery and then remove the battery.