Legal analysis
If the flow rate is far below the minimum flow rate to ensure accuracy, there will be no output (such as vortex flowmeter) or the output signal will be cut off as a small signal (such as differential pressure flowmeter), which is unfavorable and unfair to suppliers. In order to prevent the loss of benefits, for a specific set of thermal energy metering equipment, the supply and demand sides often agree that a certain flow value is the "agreed lower limit flow" according to the flow measurement range and the achievable range, and agree that if the actual flow is less than the agreed value, it will be charged according to the lower limit flow. The metrological administrative department of the people's government at or above the county level may set up metrological verification institutions according to needs, or authorize metrological verification institutions of other units to perform compulsory verification and other verification and testing tasks. Personnel who perform the verification and testing tasks specified in the preceding paragraph must pass the examination. This function is usually realized in the flow display instrument. The metrological administrative department of the local people's government at or above the county level shall, according to the needs of the local area, establish public standard instruments of measurement, which shall be used after passing the examination presided over by the metrological administrative department of the people's government at a higher level. Enterprises and institutions may, as required, establish standards of measurement for their own use, and the highest standards of measurement shall be used after passing the examination presided over by the metrological administrative department of the relevant people's government. Metrological verification shall be carried out on site in accordance with the principle of economy and rationality. Metrological verification must be carried out in accordance with the national metrological verification system table. The national metrological verification system table shall be formulated by the metrological administrative department of the State Council.
legal ground
People's Republic of China (PRC) labor contract law
Article 39 The employing unit may terminate the labor contract if the employee is under any of the following circumstances: (1) The employee is proved to be unqualified for employment during the probation period; (two) a serious violation of the rules and regulations of the employer; (three) serious dereliction of duty, corruption, causing great damage to the employer; (4) The laborer establishes labor relations with other employers at the same time, which has a serious impact on the completion of the work tasks of the unit, or the employer refuses to correct it; (5) The labor contract is invalid due to the circumstances specified in Item 1 of Paragraph 1 of Article 26 of this Law; (6) Being investigated for criminal responsibility according to law.
Forty-seventh economic compensation shall be paid according to the standard of one month's salary for each full year of work in the unit. For more than six months but less than one year, it shall be counted as one year; If it is less than six months, economic compensation of half a month's salary shall be paid to the workers. If the monthly salary of workers is three times higher than the average monthly salary of local workers announced by the people's government of the municipality directly under the central government or the city with districts where the employer is located, the standard for paying economic compensation to workers is three times the average monthly salary of workers, and the longest period for paying economic compensation to workers shall not exceed 12 years. The monthly salary mentioned in this article refers to the average salary of workers in the twelve months before the dissolution or termination of the labor contract.