You can use sweet potato U disk startup tool or nectarine U disk startup tool and Chinese cabbage U disk startup tool to make U disk startup disk. These are all good choices. Take one of them as an example!
Preparatory work:
① Download the new version of sweet potato software.
(2) USB flash drive with capacity greater than 4G and can be used normally.
Specific steps:
Step one:
Double-click to open the sweet potato U disk startup disk making tool, select "Smart Mode" in the lower left window, and then insert the prepared U disk into the usb interface of the computer. Sweet potato will automatically identify the U disk. Click the drop-down menu next to "Start Production" and select the production mode related to the column "U disk partition". If you want to personalize, you can click "Advanced Settings". For the personalization process, please refer to "Starting Personalization Course with Sweet Potato U Disk".
Step two:
After we click "Start Production", a warning window will pop up: "This operation will delete all data, which is irreversible". If there is important data on the USB flash drive, we need to back it up. After confirming that the backup has been completed or there is no important data to clear, we click OK. If the user chooses lossless production, a warning window "Lossless production is risky, and the data on the U disk cannot be completely guaranteed" will pop up, as shown in the figure below:
Step 3:
Then start making USB flash drive startup disk. The whole process depends on the situation, ranging from two to five minutes, as shown in the figure:
Step 4:
After the USB flash drive startup disk is made, a sweet potato message prompt window will pop up: "USB flash drive started successfully. Do you want to test the startup of the U disk with simulated startup? " We click "Yes" to test whether the finished USB boot disk is available.
Step five:
If you see the normal startup interface of the U disk startup disk in the simulation environment, it means that the U disk startup disk has been successfully made (note: the simulation startup interface is only for testing, please do not operate further). Finally, press the key combination "Ctrl+Alt" to release the mouse, and click the close icon in the upper right corner to exit the simulation interface, as shown in the figure below: