1. After entering the examination room, first confirm your examination information, including name, ID number, serial number, examination car number, etc. If you find any problems, please consult quickly. Don't wait for your exam.
When waiting for the exam in the examination room, we should pay attention to the situation of the venue and the order of the items. You can ask the students who have finished the exam what they need to pay special attention to in the examination room, and be mentally prepared.
Second, the exam preparation
1, adjust the seat after getting on the bus, and step on the clutch brake with both feet to get a general feeling of the clutch of the test car.
2. Adjust the angle of the left and right rearview mirrors according to the height, and then fasten the seat belt.
3. Fasten the seat belt and check whether the door is closed, whether the gear is in neutral and whether the handbrake is tightened.
4. After confirmation, wait for the electronic examiner's order and press the fingerprint to start the exam.
5. Enter the examination area according to the prescribed route and control the speed.
Before entering the examination room, wait for the last student to complete the project before entering. In each project, wait for the password of the electronic examiner to appear before operating. Don't worry.
Third, back into the warehouse.
1. After entering the examination room, park the examination car in the designated area before changing positions.
2. The whole project includes two warehousing and warehousing. After the first dumping, the warehouse should leave the warehouse in the opposite direction.
3. End the project, drive the car to the exit position and complete the exam.
Matters needing attention
① Observe the rearview mirror at any time during the whole process, confirm the distance between the car body and the sideline, and avoid the wheel pressing line.
(2) Find the right time and direction on time, so there is still room for adjustment.
(3) When the car body is not fully put into storage, don't stop prematurely, pay attention to clutch control and avoid stopping halfway.
Fourth, side parking
1, after entering the examination area, before driving to the garage, the car body is parallel to the garage sideline.
2. Go back to the garage from the right rear.
3. Pay attention to the right rearview mirror when leaving the warehouse, and confirm the distance between the right wheel and the sideline to avoid line pressing.
Matters needing attention
① Before warehousing, the wheels should keep a distance of about 30cm from the sideline, neither too close nor too far away.
② When leaving the warehouse, remember to turn on the left turn signal and then turn the steering wheel.
Five, the ramp fixed-point parking start
1, it is best to aim the car at the parking area before going uphill, so there is no need to make too much adjustment on the slope.
2. After parking, the distance between the wheel and the sideline should be within 30cm, and the front of the car should be in the yellow line area.
3, restart, slowly lift the clutch to the semi-linkage, start naturally, do not slip or stall.
Matters needing attention
① It is the easiest to stall and slip. Be sure to pay attention to the operation sequence, slowly lift the clutch, and don't forget to release the brake.
(2) when parking at a fixed point, when the sideline coincides with the front cover 1/3, it is basically within 30cm.
Six, curve driving+right turn can be carried out according to the prescribed route of the examination.
① Before entering the examination area, drive as close as possible to the outside of the route.
(2) When turning, kill the steering wheel, and loosen the clutch at the foot to prevent stalling.
Seven, complete the exam
1. Don't unfasten your seat belt and get off the bus until you hear the password "Exam is over".
2. After the exam, you have to go to the designated place to sign, and the exam is really over.