(1) The door opening direction is left inside, right inside, left outside and right outside; It should be noted that the direction of door opening directly affects the direction of door handle and lock tongue.
(2) Check whether the side plate size is appropriate. The national standard lock body side plate size is 24 * 240 mm. If it does not meet the requirements, contact the manufacturer to customize the side plate according to the door size.
(3) Confirm whether there is a gutter on the door. Judgment method: Touch the top edge of the door by hand to see whether there is a keyhole, whether the door lock is in the pop-up state, and whether there is a locking tongue pop-up on the top edge of the door.
(2) Installation demonstration
1. 1. Adjust the front panel door handle: screw on the inner screw of the door handle and adjust the direction of the door handle according to the left and right opening of the door (if the door is left open, the tail of the door handle is left open; The door opens to the right, and the tail of the door handle is to the right). When the handle is pressed, it can operate normally, indicating that the adjustment is successful.
2. According to the instructions, adjust the clutch shaft direction of the smart lock clutch. First unscrew the screw fixing the clutch cover, remove the clutch cover and spring, adjust the direction of the clutch shaft pointer to the same direction as the door handle (the tail of the door handle points to the left, and the clutch shaft pointer points to the right, otherwise), and then put the spring in the same direction to fix the clutch shaft.
3. Cover the clutch cover again and tighten the screws.
4. According to the direction of opening the door, adjust the slope direction of the soft lock tongue (the door opens inward and the slope faces outward; When opening the door, the inclined plane faces inward), use a screwdriver to forcibly insert the hole at the tail of the soft lock tongue, so that the whole soft lock tongue protrudes from the side piece, rotate it by 180 degrees to make the direction of the soft lock tongue consistent with the direction of the door, insert the lock body and screw on the screw.
5. Tighten the four screw connecting rods on the front panel, insert the outer shaft and spring, and tighten them. Then, install the front panel on the door and press the handle up and down to test whether the door handle works normally.
6. Tighten the three screws under the mounting plates of the rear panel and the front panel.
7. Insert the rear panel square shaft and the anti-lock square shaft, insert the spring, and connect the connecting wire with the connecting port. After the connection, adjust the anti-lock switch on the rear panel, the anti-lock tongue pops up, and the anti-lock switch points off, otherwise it points on, and then install the rear panel on the door.
8. Align and screw in the screws in the battery box above the rear panel, and then screw in the two small screws below the rear panel. ?
9. After inserting the battery, tighten the battery cover.
After setting the fingerprint, password and magnetic card information in the lock, it can be used normally.