Correct methods and skills of driving test subject 2: driving test subject 2: methods and skills formula

1, reverse warehousing formula

Reversing into the warehouse should be done well, and the clutch is half connected, and the speed is not high;

Look at the left (right) rearview mirror more, and reversing depends more on skill;

It's not good to stop halfway, so you have to retake the test.

Difficulties in reversing into the warehouse: you can't stop halfway, which completely negates the practice of killing the direction identification rod in situ in the electronic pile examination: park your car at the stop line 1.5 meters; When the rear of the car is on the sideline of almost two parking spaces, the steering wheel is full and backward; Feel the timing of the front of the car and the steering wheel will reverse immediately.

Suggestion: Allow a short pause before preparing for storage. Candidates can take this opportunity to observe the garage sideline with the rearview mirror and decide the angle of the steering wheel when reversing.

2. Side parking formula

There are new regulations for side parking, and you should grasp the angle visually;

Look at the white line in the rearview mirror and put the car in the garage at a time;

Don't stop halfway, and don't forget to turn on the turn signal when you start.

3, ramp fixed-point parking and start formula

There are standards for two marking lines, and 30 and 50 should be distinguished;

30 10, 50 kills hard, and the wheels and front bumper (front bumper) should stop;

Parking and slope sliding are taboo, and the hand brake and throttle should be in place;

Don't forget to turn, it shouldn't take a long time to start, and overtime won't help.

Stop and start at a fixed point on the ramp: when you hear the command, brake lightly, turn on the right turn signal, look at the right rearview mirror, turn right, turn left when the center line of the front car hits the sideline, and turn right when the front car is away from the sideline 10 cm, and keep the sideline distance. When the target arrives, stop the car and tighten the handbrake.

Start: shift gears, turn left, etc. Honk the horn, tighten the handbrake, release the brake, slowly lift the clutch, and when you lift it to the front of the car, gently fill the throttle, release the brake and start.

Passing requirements: motor vehicle drivers should judge the slope, length and width of the ramp in time through vision and feeling, and take appropriate operation methods to control the vehicle to stop and start smoothly. Correct steering, rapid gear shifting, and accurate coordination of direction, braking and clutch.

Operation essentials: First, turn on the right light, step on the clutch, step on the brake, release the accelerator, put down the handbrake, put in neutral, release the clutch and brake, and the vehicle is in the parking state; Second, prepare to start on the ramp. Turn on the left light, step on the clutch, shift to 1, step on the accelerator, slowly release the clutch and brake, and the vehicle will run.

Step 4 turn at right angles

Pass the car once and choose a good route;

You can't touch the lane sideline, and the "qualified" collision fails.

5, curve driving

If the direction is chaotic, it will be fatal, and if the speed is stable, it will set the rudder;

You can't stop halfway, and you'd better take off the wheels.

Tips for cornering: Before entering the left bay, the vehicle should drive to the right, and use the left front corner of the vehicle to keep pressing the right line. When it is necessary to change the right turn, the direction will return to the right turn and enter the right turn, and the right front corner of the vehicle will keep pressing the left line until it is completely out of the turn. Before entering the right corner, the vehicle should drive to the left and keep pressing the left line with the right front corner of the vehicle. When the left corner needs to be changed, the direction should be reversed into the left corner, and the left front corner of the vehicle should keep pressing the right line until it is completely out of the corner.

Driving skills: the examination room is actually an "S"-shaped road, but the width of the road is only 3.5 meters. First, we must keep driving in first gear, and the direction should not be too urgent. Second, when driving to the right corner, the right wheel sticks to its right kerb, and vice versa.