Driving test subject 3 simulated light voice prompt

Turn on the headlights, change the headlights into high beam lights, turn on the low beam lights at night, and alternately flash the high beam lights, low beam lights, fog lights+danger warning lights, width lights+danger warning lights.

Driving test subject 3 simulates the voice content of lighting test;

1. Please turn on the headlights-turn on the headlights (be sure to get close to the headlights, otherwise 100 points will be deducted).

2. Driving at night, no bad street lights-turn on the high beam.

3. Drive in the same direction as the car at night-turn on the low beam.

4. At night, the road fault hinders the traffic and makes it difficult to move-turn on the double flashing lights and change the headlights to width lights (small lights).

Subject 2 skills

First of all, before practicing reverse parking, we should first understand the test route, operation requirements, scoring standards, vehicle driving route map and so on. During the examination, vehicles are not allowed to stop on the way forward and backward.

From the control line at one end of the road, pour into the garage for parking, then come out of the warehouse, cross the control line at the other end, pour into the garage for parking, and finally drive out of the garage. When parking, the front wheel of the car should be pressed on the line. When the wheel is pressed on the line, you can reverse the car.

First, go straight back. When you go straight back, you can just see the line along the lower edge of the left rearview mirror. You can also see that the tracery on the right rear window overlaps with the library line, and then continue to retreat to the right. When the vehicle is driving to the right, you can observe the relationship between the body and the corner of the garage and the driving route through the right rearview mirror.