(2) In line with the conditions, the appraisal institution accepts the entrustment of the mining right holder and signs the appraisal entrustment contract;
(3) The report preparation unit shall submit the report and relevant legal documents as required by the authorized institution;
(4) According to the contents of the report, the appraisal institution employs appraisers (experts) from relevant professions to form an appraisal expert group to review the report and write personal appraisal opinions of the appraisers (experts);
(5) Determine the evaluation method, time and place, and draw up the evaluation and acceptance schedule;
(6) Hold a review meeting, the report preparation unit will report the contents of the report, and the reviewers (experts) will give personal review opinions, and the review team leader will summarize and form a review opinion (draft), and put forward opinions on modifying the report;
(7) The report preparation unit shall supplement and improve the report according to the modification opinions of the expert group, fill in the report modification comparison table, and submit it to the evaluation institution;
(8) The leader of the expert group shall, according to the official draft of the report, assist the evaluation institution to form evaluation opinions;
(9) The materials submitted by the evaluation agency according to the requirements of the Ministry of Land and Resources for reserve evaluation and filing;
(10) The appraisal agency will submit the materials required for filing to the Reserve Department of the Ministry of Land and Resources, which will countersign and propose amendments, and issue the filing certificate number after supplementation and improvement. After printing, the appraisal institution shall affix a special seal for appraisal to the Ministry of Land and Resources.
Contact: Gong
Tel: 0 10-62253057,1360119568.
E-mail :gongyufei6@vip.sina.com
Contact: Li Hongwei
Tel: 0 10-62233850, 1365 1372548.
E-mail :lhbzi@sina.com
Submit the legal documents for mineral resources reserve evaluation.
1 mineral resources reserve evaluation declaration form
Reporting unit: the full name of the prospecting or mining right holder.
Mailing address: the detailed mailing address of the unit where the prospecting or mining right owner belongs.
Contact person, telephone number and fax number: the applicant shall designate a special person as the review contact person and provide effective contact information for contact or communication.
Report writing unit: the full name of the report writing unit. (If the reporting unit and the writing unit are the same unit, this item is not required. )
Mailing address: the detailed mailing address of the place where the report writing unit is located.
Contact person, telephone number and fax number: the report writing unit shall designate a special person as the review contact person and provide effective contact information for contact or communication.
Name of mineral resources reserve report: it should be consistent with the name of the mineral resources reserve report submitted for review.
Evaluation minerals: refers to the dominant minerals declared for evaluation, and only one type is filled in.
Appraisal purpose: according to the appraisal purpose, fill in the application for mining license, change of mining right certificate, transfer of mining right, listing financing, registration statistics and others respectively.
Utilization: According to the utilization of the mineral resources reserve report, fill in infrastructure, mining, stop mining, pit closure, unused and unknown respectively.
Report type: according to the types of mineral resources reserves report, fill in exploration, verification, stop mining and pit closure respectively.
Resource reserve scale: according to the total scale of mineral resources reserves of major minerals, fill in large, medium and small.
Production scale: according to the production scale of production mine or proposed mine, fill in large, medium and small. (Not required if the feasibility study or pre-feasibility study has not been completed. )
Sources of exploration funds: projects funded by the central government (geological exploration fees allocated by the state), geological exploration fund projects, projects funded by units or competent departments, projects funded by local governments, and other funds (foreign cooperation, paid use of results, etc.). ) and social funds (such as exploring the geological market and absorbing funds from outside the industry). ).
Exploration degree: according to the geological exploration degree of the mining area, fill in the general survey, detailed investigation, exploration and verification.
Applicant system: according to the applicant system, fill in geology and mineral resources, coal, metallurgy, chemical industry, building materials, nuclear industry, non-ferrous metals, armed police gold, mines, oil and gas and others.
Validity period of exploration right or mining right: fill in from. }
The organ of first instance: refers to the competent unit of the prospecting or mining right holder. If there is no competent unit, it is not required.
Main minerals: all minerals whose reserves are calculated separately.
Industrial indicators: refers to the basis for adopting industrial indicators and the contents of industrial indicators.
Mineral resources reserves: fill in the quantity and total amount of various mineral resources reserves in this declaration and review.
2 mine owner's undertaking
(1) in duplicate;
(2) Signature of the legal representative;
(3) Official seal of the employer;
(4) The mine owner is the client of this report review.
3. Letter of commitment from the reporting unit
(1) in duplicate;
(2) Signature of the legal representative;
(3) Official seal of the report preparation unit.
4. Approval of mining and exploration licenses/demarcation of mining areas
(1) duplicate;
(2) The scope and elevation of the mining/exploration license shall be consistent with the actual work scope;
(3) The coordinate inflection point of the mining/exploration license shall be consistent with the mining/exploration scope of the mining area.
5 Superimposed map of the estimated range of resource reserves and the demarcation of mining license/exploration license/mining area.
(1) in duplicate, printed on A4 paper;
(2) The estimated range of resource reserves refers to the distribution range of ore bodies within the mining license/exploration license;
(3) The plan must indicate the direction, latitude and longitude, scale (expressed by line scale) and legend of the compass;
(4) The range is indicated by dotted line plus inflection point number (inflection point number of exploration license is 1, 2,3 …, inflection point number of mining license is 1, 2,3 …, inflection point number of delimiting mining area is 1, 2,3 …, and inflection point number of resource reserve estimation range is 1.
(5) A list of inflection point coordinate data (a set of data columns have overlapping ranges, and indicate that the estimated range of resource reserves coincides with the mining right certificate or the designated mining area);
(6) The legend is rectangular, with diagonal lines in it, and inflection point numbers are marked at the four corners. The marginal notes are the estimated range of resource reserves and inflection point coordinates, mining/exploration license or designated mining area and inflection point coordinates;
(7) build the official seal of the owner.
Figure 6 Relationship between this report and the estimated range of resources and reserves in the latest approval report
(1) in duplicate, printed on A4 paper;
(2) The plan must indicate the direction, latitude, longitude and scale of the compass (expressed in line scale);
(3) There are two legends: the estimated range of resource reserves in this report is indicated by dotted lines and inflection points (the inflection points of the estimated range of resource reserves in this report are 1, 2,3 …, and the estimated range of resource reserves in the latest approved report is a, b, c …);
(4) The legend of the estimated range of resource reserves in this report uses a right diagonal line, and the legend of the estimated range of resource reserves in the latest reply report uses a left diagonal line;
(5) For the coal exploration report, the range of pre-mining lots is increased, the inflection point numbers are indicated by Ⅰ, Ⅱ and Ⅲ, and the legend is indicated by horizontal lines;
(6) The list of inflection point coordinate data indicates (a set of data has overlapping range, indicating that the estimated range of resource reserves in this newspaper is consistent with the latest approval report).
7. Copy of the exploration qualification certificate of the report preparation unit (in duplicate)
8 mineral resources exploration/resource reserves verification report (including drawings, schedules, annexes and text descriptions)
(1) Number of reports submitted by the mine owner:
Small report: 1 complete report, plus 2 written reports (1 ~ 2 reserve appraisers);
Medium-sized report: 2 sets of complete reports plus 3 written reports (3 ~ 5 reserve appraisers);
Big report: 2 sets of complete reports, plus 4 written reports (5 ~ 7 reserve appraisers).
(2) A text summary of about 400 words is attached at the beginning of the text of the report.
(3) The cover and title page of the report 1 contains: the name of the report is above, the mine owner and the date of submission of the report are below, and the official seal of the mine owner is affixed.
(4) The contents of the title page 2 of the report are: the name and deadline of the report are on it; Among them are the report submitting unit, legal representative and technical director, with the official seal of the report submission form affixed; The following are the report preparation unit and technical responsible personnel, and the official seal of the preparation unit is affixed; At the bottom is the report submission date.
(5) Submit a set of formal drafts after revision, plus a written report.
Table 9 Changes of Mineral Resources Reserves
(1) Name, approval unit, time and document number of the latest approval report, and estimated range of resource reserves (geographical coordinate range, exploration line range, elevation, etc.). ) and approved resource reserves;
(2) the mining situation and the payment of resource compensation fees from the latest approval time to the submission time of this report;
(3) Resource reserves estimated in the latest approved report within the estimated scope of this report;
(4) Resource reserves estimated in this report;
(5) Remaining resource reserves beyond the estimated range of this report and within the estimated range of the latest approved report.
10 Description of resource reserves changes in this report and the latest approved report.
10. 1 exploration report (examination and approval of exploration license and demarcation of mining area)
(1) This content was added after the report of resource reserve estimation results;
(two) the name, approval unit and approval number of the latest approval report;
(3) Resource reserves approved by the latest examination and approval report;
(4) The relationship between this report and the estimated range of resource reserves in the latest approved report (partial overlap, inclusion and complete coincidence);
(5) The resource reserves estimated in the latest reply report of the overlapping part;
(6) The resource reserves of the overlapping part are estimated in this report;
(7) Changes in the resources reserves of overlapping parts;
(8) explain the reasons for the change.
10.2 verification report (mining license)
(1) This content was added after the report of resource reserve estimation results;
(2) the name of the latest approval report, approval unit, approval time, approval number and approved resource reserves;
(3) The estimated resource reserves in the latest approval report in the mining license;
(4) Reserved resources within the mining license estimated in this report;
(5) Changes in resource reserves within the mining license;
(6) Explain the reasons for the change: ① the resource reserves increased by production prospecting; (2) The accumulated resource reserves (including production and loss) consumed since the latest approval report; ③ contrast change of exploration and mining (indicating the contact change of ore bodies); (4) Recalculation error (caused by different industrial indicators, exploration types, reserve categories, block division, estimation methods, etc.). ).
1 1 cross-reference table of changes in resources and reserves
1 1. 1 exploration report (examination and approval of exploration license and demarcation of mining area)
(1) Name, approval unit and approval number of the latest approval report;
(2) Resource reserves approved by the latest approval report;
(3) The estimated resource reserves in the latest reply report of the overlapping part;
(4) The resource reserves of the overlapping part are estimated in this report;
(5) the change of resource reserves in overlapping parts;
(6) Resource reserves estimated in this report.
1 1.2 verification report (mining license)
(1) Name, approval unit and approval number of the latest approval report;
(2) Resource reserves approved by the latest approval report;
(3) The estimated resource reserves in the latest approval report in the mining license;
(4) Changes in resource reserves (production prospecting, production volume, loss volume, comparison between exploration and production, recalculation changes);
(5) Resource reserves within the mining license estimated in this report.
12 report version comparison table
Fill in the report modification comparison table one by one according to the modification opinions put forward by experts in the Resource Reserve Review Record and Feedback Form. Location refers to the page number or chapter.
Mineral resources reserve evaluation declaration form
power of attorney
The review client promises that the following submitted materials are true and objective, and there are no false contents such as forgery, fabrication, alteration and tampering:
(1)×× contents of mineral resources reserve report (including attached drawings, schedules and annexes) and the original exploration data and basic data involved therein;
(2) ××× copy of exploration/mining license/approval letter for delimiting mining area;
(3) ×××× exploration/mining license scope/overlay drawing delineating mining area and calculation range of mineral resources reserves (including inflection point coordinates of calculation range of mineral resources reserves);
(4) Other materials related to the evaluation work that the evaluation institution thinks should be submitted.
The review client voluntarily bears the consequences of the above inaccurate information submitted for review.
Signature and seal of legal representative: (seal of entrusting party)
Date, year and month
Table of changes in mineral resources reserves
Table of Changes in Resource Reserves of Overlapping Part of Verification Exploration Scope and Latest Verification Exploration Scope
Comparison table of XXX mine resources and reserves (verification report)
Comparison table of XXX mine resources and reserves (exploration report)
Report version comparison table